User manual

Setup (Iss. 05) • 12

Setup

Power Adaptor and Supply

Connect the PS-9000 power adaptor to the power supply connector. The

PS-9000 provides regulated +5V DC (5%) @ up to 2A. The DC power cord has

a locking connector that securely fastens into the power supply DC jack on the

ADC-9032. The ADC-9032 has a standard miniature power jack (center pin

positive). If using an adaptor other than the PS-9000, ensure that the polarity is

correct and that the voltage is +5V DC regulated to 5% and it can supply

sufficient current for the ADC-9032. Use of improper adaptors may damage the

ADC-9032 and will void the warranty.

Installations outside of North America using line voltages of 200 - 240 Volts

require a plug, certified for the country of use, to be installed on the supplied

line cord.

Refer to the section “Important Regulatory and Safety Notices to Service

Personnel” at the front of this manual for details.

If using an adaptor other than the PS-9000, ensure that:

• the polarity is correct

• the voltage is +5V DC regulated to 5%

• sufficient current for the ADC-9032 is supplied

Caution — Use of improper adaptors may damage the ADA-9503

and will void the warranty.

Cable Connections

Connect the analog input and SDI output cables to the ADC-9032 according to

the designations indicated on the chassis label. The input is internally terminated

at 75ohms. It is not necessary to terminate unused outputs.

Figure 5 ADC-9032 — Cable Connections Label

POWER

SUPPL

CVBS IN

SDI OUT 2 SDI OUT 4

SDI OUT 1 SDI OUT 3