User manual

ASI-310 User Manual (Iss. 03) Installation • 2–5
Installing the ASI-310
Use the following procedure to install the ASI-310 in a DFR-8300 series frame:
1. Locate the Rear Module you installed in the procedure “Installing a Rear Module” on
page 2-4.
2. Hold the ASI-310 by the edges and carefully align the card-edges with the slots in the
frame.
3. Fully insert the card into the frame until the rear connection plus is properly seated in the
Rear Module.
4. Verify whether your label is self-adhesive by checking the back of the label for a thin
wax sheet. You must remove this wax sheet before affixing the label.
5. Affix the supplied Rear Module Label to the BNC area of the Rear Module.
This completes the procedure for installing the ASI-310 in a DFR-8300 series frame.
Notice — Heat and power distribution requirements within a frame may dictate specific slot
placements of cards. Cards with many heat-producing components should be arranged to
avoid areas of excess heat build-up, particularly in frames using convectional cooling.