User manual

5–2 • Using the On-Screen Menus ASI-310 User Manual (Iss. 03)
On-screen Display Overview
This section briefly describes how to access and navigate through the menus in the on-screen
display (OSD). The OSD feature is displayed on a separate composite monitoring output. When
activated, the card status and parameters can be viewed and adjusted using the card-mounted
menu switch and an easy to use menu system.
For More Information...
• on the switch locations on the card-edge, refer to the section “Card Overview” on
page 3-2.
OSD Switch Overview
The Menu switch is used to navigate the ASI-310 menu system and configure item parameters.
This switch is a five-direction, square, finger joystick.
Figure 5.1 Menu Switch
With the card-edge facing you, use the following menu switch actions and Figure 5.1 to navigate
the menu parameters:
• In — pressing once brings the menu system onto the monitor output, holding for two
seconds exits the menu system. This position is also used to enter the menu values and
parameters.
• Up — pressing once selects the menu, item, or value above the current selection, holding
scrolls to the top of the available selections.
• Down — pressing once selects the menu, item, or value below the current selection,
holding scrolls to the bottom of the available selections.
• Forward — pressing once moves from menu to item, or item to value.
• Back — pressing once moves from value to item, or item to menu.
Up
Down
Back
Forward
In
In