User manual

ASI-310 User Manual (Iss. 03) Using the On-Screen Menus • 5–3
OSD Layout and Navigation
When the ASI-310’s front OSD switch is in the normal “in” position, the OSD is off and its
output jack is the output from the 310-to-ASI converter. To use the OSD, move it to the “out”
position (closer to the front-edge of the card). A menu, similar to the one shown below, is
displayed on the OSD output.
Main OSD Screen — Product Status
The top line of the screen has three items (from left to right): Product, Settings, and Exit.
Product
This is the first in a list of Status screens. To view these screens, press the Menu switch In to
highlight the word Product, then press Menu switch Down once to view the GPIO Status screen,
and Down again for the next screen in the sequence. These are the same Status fields described in
the chapter “Configuration”.
Settings
This is the first in a list of Setup menus. To view these, press the Menu switch Forward to
advance the selection bar to the word Settings, then press the Menu switch In to highlight it.
Now press the Menu switch Down once to view the ASI to 310 menu, and Down again for the
next menu in the sequence. These are the same Setup menus described in the chapter
“Configuration”
Exit
To turn off the OSD: press the Menu switch Forward to advance the selection bar to the word
Exit, then press the Menu switch In.
To turn the OSD back on, press the Menu switch In again. This selection is somewhat redundant,
since you should return the front OSD switch to the “in” position anyway to turn the OSD off.
Note — While editing numeric fields, Forward and Back allow you to select
individual digits, while Up and Down change the value of the selected digit.Numeric
entry is completed by pressing the Menu switch In. This also applies to editing
alphanumeric values in the Edit Strings menu.
Slot 8
ASI-310 Convertor
EXITSettingsProduct
Product
Manufacturer
Hardware Rev
Software Rev
Firmware Rev
Rear Module
Current (mA)
Serial Number
ASI-310
B
A
A.2
40
400
N/A
OSD Enabled