User manual

2–4 • Installation DRA-8604 User Manual (Iss. 02)
5. Align the top hole of the rear module with the screw hole on the top edge of the frame
back plane.
6. Using a Phillips screwdriver and the supplied screw, fasten the rear module to the back
plane. Do not over-tighten.
7. Verify whether your Rear Module Label is self-adhesive by checking the back of the
label for a thin wax sheet. You must remove the wax sheet before affixing the label.
8. Affix the supplied Rear Module Label to the BNC area of the Rear Module.
9. Ensure proper frame cooling and ventilation by having all rear frame slots covered with
rear modules or blank metal plates.
To install the card in the openGear frame
1. Locate the Rear Module you installed in the procedure “To install the rear module in
the openGear frame” on page 2-3.
2. Hold the card by the edges.
3. Carefully align the card edges with the slots in the frame.
4. Fully insert the card into the frame until the rear connection plugs are properly seated on
the midplane and rear modules.