User manual

3–2 • Configuration DRA-8604 User Manual (Iss. 02)
Card Overview
This section describes the Bootload button located on each card surface. There are no other
card-edge controls as all configuration and setup is done using the menus in DashBoard. Refer to
Figure 3.1 for location of this button.
Figure 3.1 Card-edge Controls
1. Bootload Button
This button is used for factory service in the unlikely event of a complete card failure. Do not use
this button unless advised by Ross Technical Support.
For More Information on...
• the Bootload process, refer to the section “Bootload Button” on page 6-2.