Operator`s manual

1–4 • Introduction CrossOver 16 User Manual (v4.0)
with the USB port, replace the frame door to ensure
proper airflow through the frame.
To remove the frame door:
Figure 1.6 Removing the Frame Door
1. Using both hands, grasp the door tabs.
2. Gently pull the door tabs towards the center of
the door, releasing the door from the frame.
3. Pull the door towards you and place it on a
clean, flat, static-free surface.
To attach the frame door:
1. Using both hands, slide the door onto the frame
ensuring that the door tabs engage sides of the
frame.
2. Pull and release the door tabs to ensure the
frame door is securely attached to the frame.
Menu System
There are two ways to access the menu system:
• Pressing MENU
• Using Auto-follow
To access a menu using the MENU button:
1. Press MENU. The Wipe Pattern buttons
illuminate.
2. Press a Wipe Pattern button to select the
corresponding menu (menu names are printed
beneath the Wipe Pattern buttons).
Auto-Follow
Auto-follow displays the menu for a selected
function when the button for that function is pressed.
Auto-follow is always active — when you press any
button on the control panel that has a corresponding
menu, the menu is automatically displayed.
External Devices and Auto-Follow
When you have external devices connected to your
switcher, you can quickly access the device control
menu even when the menu system auto-follows to
another menu. Pressing a button with an auto-follow
menu a second time displays the device control menu
if an input source assigned to that device is active.
Repeatedly pressing the button toggles between the
auto-follow menu and the device-control menu.
For More Information on...
• external device control, refer to the section
“Device Control” on page 4-11.
Menu Navigation
Some menus have multiple pages. When the NEXT
button is lit, multiple menu pages exist. Press NEXT
to move to the next menu page. Press and hold
NEXT and then press MENU to move to the
previous menu page.
Some menus contain sub-menus. Press the knob
corresponding to the sub-menu to access it. Press and
hold the NEXT button and then press the RECALL
button to return from the sub-menu.
If you wish to return to the first page of a top-level
menu, Press and hold the NEXT button and then
press the STORE button.
Note:
• You can exit the menu system by pressing any
button other than a Wipe Pattern or source button
while the menu system is active.
Knobs
The control panel has three continuously rotatable
pushbutton knobs located below the display screen.
The knobs are used to select and alter menu options.
To use the knobs:
• Rotate the knob to adjust the corresponding value.
To default a value using the knobs:
• Double-press a knob to default the value currently
associated with that knob.
POWER
1
1
2 2
1
2