Operator`s manual

2–4 • Configuration CrossOver 16 User Manual (v4.0)
5. Use the Frming knob to set the aspect ratio
conversion mode. You can choose from the
following:
• Full — The video signal is scaled
disproportionately to fill the display of the
new aspect ratio. Aspect distortion occurs as
the image is stretched/compressed to fit in the
new aspect ratio.
• Zoom — The central portion of the video
signal is zoomed to fill the display of the new
video format. No aspect distortion is
introduced.
• LttrBx — Black bars are added to the top and
bottom of a 16:9 image to display correctly in
a 4:3 video format.
• PllrBx — Black bars are added to the right
and left of a 4:3 image to display correctly in
a 16:9 video format.
6. Press NEXT.
7. Press the Fcfs1-4 knob to save your
changes.
8. Press the Confrm knob to commit the
change and exit the FCFS menu. Press the
Cancel knob to return to the FCFS menu for
further editing.
Note:
• If one FCFS channel in a bus-pair is turned off, the
paired FCFS channel is also turned off.
• The switcher is set to switch on the first field
when using Bus mode.
• If a video format not compatible with the currently
defined conversion is used, the video image is
frozen with the last successfully processed image
frame.
For More Information on...
• switch on Field/Frame settings, refer to the section
“Field Switch Selection” on page 2-13.
• assigning an FCFS channel, refer to the procedure
“To assign an FCFS channel:” on page 2-2.
• switcher video formats, refer to the section
“Switcher Video Format” on page 2-1.
Output Reference Sync
The switcher has three reference outputs that can be
configured independently.
Setting the Output Reference Sync
If you are using one of the output references to time
external devices, ensure that they are connected to
the appropriate REF OUT 1, REF OUT 2, or REF
OUT 3 outputs.
Different applications require different output
reference formats and delay settings. Consult a
facility engineer for assistance in configuring these
settings.
To set the output reference sync:
1. Press MENU.
2. Press the REF Wipe Pattern button.
3. Press NEXT until OSync is displayed.
4. Use the OSync knob to select the reference
output you wish to configure. You can choose
from the following:
• OSync 1 — Configure reference output 1.
• OSync 2 — Configure reference output 2.
• OSync 3 — Configure reference output 3.
5. Press the OSync knob to display the
Output Sync menu.
6. Use the OSync1-3 knob to set the output
reference format. You can choose from the
following:
• Off — No output reference signal is
generated.
• NTSC/PAL — Reference format is set to
standard definition.
• 720p — Reference format is set to 720p.
• 1080i — Reference format is set to 1080i.
7. Use the Mode knob to configure the
different delay settings for the selected output
reference formats. You can choose from the
following:
• V — Configure vertical delay (lines).
• H — Configure horizontal delay (pixels).
• F — Configure frame delay (frames)
(NTSC/PAL output reference format only).
8. Use the Value knob to set the selected delay
value.
9. Press the left knob to save your changes.
10. Press the Confrm knob to commit the
change and exit the Output Sync menu. Press
NEXT
MENU
NEXT