Operator`s manual

2–10 • Configuration CrossOver 16 User Manual (v4.0)
12. Repeat steps 9 to 11 for Mask (network mask),
and Gatwy (network gateway).
13. Press the left knob to save all network
settings.
14. Press the Confrm knob or the Reboot
knob to commit the changes. Press the
Cancel knob to discard the changes and return
to the previous setting.
Note:
• If you are switching from DHCP to static IP mode,
a reboot is required.
Bus Map
You can re-map the source buttons on your switcher
if you wish to customize the order of inputs and
Media-Store channels on each bus row. Each source
button can have two inputs assigned (a standard input
and a shifted input).
Each bus row shares the same button mapping.
To modify the Bus Map:
1. Press MENU.
2. Press the CONFIG Wipe Pattern button.
3. Press the BusMap knob to display the Bus
Map menu.
4. Use the XptBtn knob to select the source
button to modify.
5. Use the Input knob to select the desired
input source or Media Store channel. Select
Shift if you wish this button to be a Shift
button.
6. Use the Shift knob to select the desired
input source or Media Store channel assigned to
the shifted state of the selected source button.
Switcher Personality
The switcher has customizable features that allow
you to tailor operation to your personal preferences.
Customizing the Panel Glow
Panel buttons are set to a glow color which is used
when the button is not selected. This glow color can
be customized.
To customize the Panel Glow color:
1. Press MENU.
2. Press the USER Wipe Pattern button.
3. Press the Scheme knob to display the
Color Scheme menu.
4. Use the HUE knob to adjust the Panel Glow
hue.
5. Use the SAT knob to adjust the Panel Glow
saturation.
6. Use the LUM knob to adjust the Panel Glow
luminance.
Note:
• It is not recommended to set the Panel Glow color
to red. Red indicates a source is on-air.
For More Information on...
• hue, saturation, and luminance, refer to the section
“Selecting Colors” on page 1-6.
Saving Color Schemes
You can save a custom Panel Glow color scheme so
that it may be recalled as needed.
To save a custom Panel Glow color scheme:
1. Modify the Panel Glow to obtain the desired
appearance.
2. Press MENU.
3. Press the USER Wipe Pattern button.
4. Press the Scheme knob to display the
Color Scheme menu.
5. Press NEXT until Save is displayed.
6. Use the Save knob to select the custom
scheme you wish to save.
7. Press the Save knob to save the color
scheme.
8. Press the Confrm knob to commit the save
(if there was a color scheme saved to the
selected custom scheme, it is overwritten). Press
the Cancel knob to cancel the save.
MENU
MENU
MENU
NEXT