Operator`s manual

2–14 • Configuration CrossOver 16 User Manual (v4.0)
For More Information on...
• external editor control, refer to the section “Editor
Port” on page 4-17.
• installation and configuration of the TSC-9902
LTC to Serial Converter, refer to your TSC-9902
documentation.
• Live EDL, refer to the section “Live Edit Decision
Lists (EDL)” on page 4-7.
Transition Area Behavior
You can set the behavior of the transition area to suit
your needs.
To configure the Next Transition Area behavior:
1. Press MENU.
2. Press the PERS Wipe Pattern button.
3. Press NEXT until Trans Area is displayed.
4. Press the Trans Area knob to display the
Transition Area menu.
5. Use the Trans knob to set the behavior of
the Next Transition area after a transition is
performed. You can choose from the following:
• Reset — The Next Transition area is reset to
a background dissolve transition
• NotRst — The Next Transition area is not
reset.
6. Use the Auto 2 knob to set the behavior
when a a transition is paused by pressing AUTO
TRANS during a transition. You can choose
from the following:
• HltFwd — The transition pauses. When you
resume the transition, it completes as
originally set.
• HltRev — The transition pauses. When you
resume the transition, the transition proceeds
in reverse and the switcher returns to the
on-air state it was in before the transition was
started.
• Rev — The transition immediately reverses
and the switcher returns to the on-air state it
was in before the transition was started.
7. Use the ARKey knob to set whether a Key
remains or is removed from the Next Transition
area after a dedicated key transition is
performed. You can choose from the following:
• Off — The Key is removed from the Next
Transition area after a dedicated key
transition is performed.
• On — The Key remains active in the Next
Transition area after a dedicated key
transition is performed.
8. Use the RlClip knob to set whether GPI
outputs assigned to input sources are triggered
before a transition. You can choose from the
following:
• Force — GPI outputs assigned to input
sources going on-air in a transition are always
triggered.
• User — You can choose whether GPI outputs
assigned to input sources going on-air in a
transition are triggered.
NEXT button Secondary Function
You can configure a secondary function of the
NEXT button allowing it to be used, in conjunction
with the Wipe Pattern buttons, to trigger GPI outputs.
To configure the NEXT button secondary
function:
1. Press MENU.
2. Press the PERS Wipe Pattern button.
3. Press NEXT until NextBn Func2 is
displayed.
4. Press the NextBn Func2 knob to display
the Secondary Function menu.
5. Use the Func knob to select the secondary
function for the NEXT button. You can
choose from the following:
• None — The NEXT button is not
assigned a secondary function.
• GPO — The NEXT button (in
combination with the Wipe Pattern buttons) is
used to trigger GPI outputs.
6. If you selected GPO in the previous step, use
the Bank knob to select which GPI output
bank you wish to control.
Note:
• Only one GPI output bank can be triggered at a
time.
MENU
NEXT
NEXT
MENU
NEXT
NEXT
NEXT
NEXT