Operator`s manual

5–2 • Custom Controls CrossOver 16 User Manual (v4.0)
be stored in a custom control, with the following
exceptions:
• Diagnostic functions
• Confirmation dialogs
• Panel-specific functions
To Record a Custom Control:
1. Press MENU > EDIT.
2. Use the Bank knob to select the bank that
the custom control you want to record will be
stored on, or select the bank directly.
3. Use the CC knob to select the custom
control that you want to record, or select the
custom control on the bus directly. If the custom
control already has a macro recorded, an
À is
shown next to the number.
4. Use the Func knob to select Record.
5. Press the Func knob to start recording.
6. Insert the events you want to record. These can
include source selections, key types, transitions,
and menu selection, for example. Special
functions can also be inserted.
7. Press START/STOP to stop recording. You
can press CANCEL if you do not want to
store your changes to the custom control.
Note:
• You can also start recording a custom control by
selecting the bank and custom that you want to
record to, and press START/STOP.
• Each custom control can have a maximum of 99
events, plus the End event.
Inserting Special Functions
Special functions allow you to include events not
associated with a button press into a custom control.
A special function can be inserted into any existing
custom control, or used when creating a new custom
control.
To Insert a Special Event into a Custom Control:
1. Start recording or editing your custom control
where you want to insert the special event.
2. Press INSERT.
3. Use the Insert knob to select the event you
want to insert. Refer to Table 5.1 for a list of
available commands.
4. Press the Insert knob to insert the selected
command.
5. When you are finished inserting events, press
START/STOP to stop recording. You can
press CANCEL if you do not want to store
your changes to the custom control.
Note:
• You can insert a special custom control command
quickly by pressing and holding the INSERT
button. The buttons on the custom control bus
change to quick insert buttons. The function of
each button is shown on the mnemonic display.
MENU
EDIT
START
STOP
CANCEL
START
STOP
INSERT
Table 5.1 Special Custom Control Commands
Command Description
Hold
The Hold custom control allows you place a
command in a custom control that will stop a
custom control where the hold is placed in the
custom control. To continue the custom control,
you must press the custom control button again, or
use a GPI trigger.
Pause
The Pause custom control allows you to place a
command in a custom control that will stop a
custom control where the pause is placed in the
custom control. The length of time that the custom
control is paused is set when the pause event is
inserted into the custom control.
When holding the
INSERT button, pauses
are shown as
Px, where x is the length of the
pause in frames.
Loop
The Loop custom control allows you to have a
custom control run continuously until you stop it,
or a Cancel/Cancel All custom control command is
executed from another custom control.
GPO
The GPO command allows you to trigger a
pre-selected output GPI using a custom control.
CutKey
The Cut Keys custom control allows you create a
custom control that will cut keys on or off.
START
STOP
CANCEL
INSERT
INSERT