Specifications

9.
Use the Pattrn knob to select the mask pattern
you want to use. You can also select the pattern
by pressing the pattern button directly.
10.
Use the X Pos knob to position the mask
horizontally. You can also use the positioner.
11.
Use the Y Pos knob to position the mask
vertically. You can also use the positioner.
12.
Press NEXT.
13.
Use the Aspect knob to adjust the aspect ratio
of the pattern. Not all patterns can be adjusted.
14.
Use the Border knob to turn on the border and
adjust the size of the border.
15.
Use the Soft knob to adjust the softness of the
border.
16.
Press NEXT.
17.
Use the Rot knob to rotate the pattern. Not all
patterns can be rotated.
18.
Use the HMult knob to multiply the pattern
horizontally.
19.
Use the VMult knob to multiply the pattern
vertically.
To Box Mask a Key
Box masks can be adjusted for size, location, rotation,
and multiplication.
1.
Select the keyer that you want to set up a mask
for.
2.
Press NEXT. Depending on the key type and
features set up for the key, you must press NEXT
multiple times to get to the next step.
3.
Use the Mask knob to select Box.
4.
Use the M-Frce knob to force the area inside
the mask region to the foreground (On).
5.
Use the M-Inv knob to invert the masked area
with the unmasked area (On). The portion of the
key that was masked out is now visible, and the
portion that was visible is masked.
6.
Press NEXT.
7.
Use the X Pos knob to position the mask region
horizontally. You can also use the positioner.
8.
Use the Y Pos knob to position the mask region
vertically. You can also use the positioner.
9.
Use the Size knob to adjust the size of the mask
region.
10.
Press NEXT.
11.
Adjust the position of the left and right sides of
the mask as follows:
a)
Use the Left/R knob to adjust the position
of the left side of the box mask.
b)
Press the Left/R knob.
c)
Use the L/Right knob to adjust the position
of the right side of the box mask.
12.
Adjust the position of the top and bottom sides
of the mask as follows:
a)
Use the Top/B knob to adjust the position
of the top side of the box mask.
b)
Press the Top/B knob.
c)
Use the T/Bttm knob to adjust the position
of the bottom side of the box mask.
Split Keys
A Split key allows you to assign a different alpha source
for a key than the ll/alpha associations that are set up
during conguration, or to use a separate alpha source
for a Self key.
A split key can be applied to an AUTO SELECT, or
SELF KEY.
To Set Up a Split Key
A split key works on an Auto Select or Self Key that
has been set up and you want to apply a different alpha
to.
1.
Set up your key with the video source you want
to use.
2.
Press and hold the Auto Select or Self Key,
depending on the key type you are splitting.
3.
Press the source button on the key bus for the
alpha source you want to use.
Tip: If the new alpha source is not assigned to a
source button, press any other button on the key bus
and use the Alpha knob to select a different alpha
source.
4.
Press the Alpha knob to accept the new alpha.
Key Copy
You can copy the entire contents of a keyer to another
keyer in the same, or a different ME. The entire contents
of the destination keyer are replaced with the contents
of the source keyer.
Carbonite Operation Manual (v8.0) — Keying • 37