User manual

4–8 • Advanced Operation CrossOver 6 / 12 User Manual (v1.4)
10. Press the Confrm knob to perform the load.
Press the Cancel knob to cancel the load.
Note:
• You do not need to load memory banks or
registers on the USB drive to the same memory
banks or registers on the switcher.
• If you load an empty memory bank or register
from a USB drive, the destination bank or register
on the switcher is erased.
For More Information on...
• using the memory system, refer to the section
“Using the Memory System” on page 4-1.
• accessing the USB port, refer to the section
“Frame Overview” on page 1-3.
Ô Software Upgrades
Software upgrades stored on a USB drive can be
uploaded to the switcher.
To upgrade the switcher software:
1. Copy a software upgrade file onto a USB drive.
Do not store multiple upgrade files on the same
USB drive.
2. Insert the USB drive with the software upgrade
file into the USB port.
3. Press MENU.
4. Press the RESET Wipe Pattern button.
5. Press NEXT until Run Software Upgrade
From USB is displayed.
6. Press the left knob.
7. Press the Confrm knob to initiate an upgrade.
Press the Cancel knob if you do not wish to
perform an upgrade.
The menu displays a message indicating the software
upgrade is in progress. The Upgrade LED on the rear
of the switcher is lit, indicating an upgrade is in
progress.
Note:
• Copy the upgrade file to the root level of the USB
drive. Do not copy the upgrade file into a folder.
• Upgrades can take several minutes to complete.
For More Information on...
• accessing the USB port, refer to the section
“Frame Overview” on page 1-3.
Completing a Software Upgrade
When the software upgrade is complete, the menu
displays a message indicating the software upgrade
was successful, the Upgrade LED on the rear of the
switcher turns off, and the switcher performs an
automatic restart.
Once the switcher restarts, it is ready to use. You can
safely remove the USB drive.
Note:
• If you are upgrading a switcher as a result of a
corrupt configuration or a previously failed
upgrade, you may need to reconfigure the network
address and reload switcher memories.
Ô Advanced Keying
The Auto Select, Chroma Key and Wipes can be
modified to give them more distinct qualities and
personalize your images.
Auto-Select Key Fine Tuning
You can modify the alpha channel settings for
Auto-Select Keys to control the blending of
transparent areas.
For More Information on...
• how to associate alpha and video inputs, refer to
the section “Input BNC Configuration” on
page 2-6.
Modifying Auto-Select Keys
If the Auto-Select Key is shaped or unshaped, the
following parameters can be modified:
• Transparency
•Mask
The Transparency function allows you to adjust the
transparency of the channel from completely opaque
to completely transparent. As the level of
transparency is adjusted, the graphic in the menu
changes to represent the current percentage of
transparency.
6
4 5
3