Operator`s manual

CrossOver 6 / 12 User Manual (v4.0) Memories, USB Storage, and Upgrades • 5–3
memory so that the desired transition is performed
after the memory is recalled.
• Memory (Recall Only) — The memory
attributes stored in the memory are used.
• NoRun — A transition is not performed after the
memory is recalled. This is the default setting.
• Run — An auto transition is performed after the
memory is recalled.
Shared Pattern Recall (SrdPat)
SrdPat sets whether the pattern generator that is
shared between the key masks and washes is
recalled.
• Memory (Recall Only) — The memory
attributes stored in the memory are used.
• NoRcl — The pattern generator is unchanged by
the memory recall.
• Recall — The pattern generator settings may be
recalled with the memory. Other attributes can
prevent the pattern generator from recalling. This
is the default setting.
Key Bus Recall (KeyBus)
KeyBus sets whether the sources selected on the
Keyer bus, when the memory was stored, are recalled
with the memory.
• Key — Selects the keyer you want to set the
memory attribute for.
• Memory (Recall Only) — The memory
attributes stored in the memory are used.
• NoRcl — The sources stored in the memory are
not recalled.
• Recall — The sources that were stored in the
memory are recalled and replace the currently
selected source on the key bus. This is the default
setting.
Key Active Recall (KActiv)
KActiv sets whether the on-air status of the keyer is
recalled with the memory. For example, if a key is
on-air in a memory, but off-air before the recall, the
key will not be cut on-air with the recall if KActiv is
set to NoRcl.
The operation of the Key Active attribute is effected
by the Memory AI feature.
• Key — Selects the keyer you want to set the
memory attribute for.
• Memory (Recall Only) — The memory
attributes stored in the memory are used.
• NoRcl — The on-air status of the selected keyer
is not recalled.
• Recall — The on-air status of the selected keyer
is recalled with the memory. Keys may be cut on
or off-air with the memory recall. This is the
default setting.
Key Type Recall (KType)
KType sets whether the key type is recalled with a
memory.
• Key — Selects the keyer you want to set the
memory attribute for.
• Memory (Recall Only) — The memory
attributes stored in the memory are used.
• NoRcl — The key type stored in the memory for
the selected keyer is not recalled with the memory.
If the current key type does not match the key type
in
the memory, none of the key parameters, excpet
on-air state, are recalled.
• Recall — The key type stored in the memory for
the selected keyer is recalled with the memory.
This is the default setting.
Key Mask Recall (KMask)
KMask sets whether key mask settings are recalled
with a memory. Refer to the section “Shared Pattern
Recall (SrdPat)” on page 5-3 for information on the
shared pattern mask for keyers.
• Key — Selects the keyer you want to set the
memory attribute for.
• Memory (Recall Only) — The memory
attributes stored in the memory are used.
• NoRcl — The key mask settings stored in the
memory for the selected keyer are not recalled
with the memory.
• Recall — The key maks settings stored in the
memory for the selected keyer are recalled with
the memory. This is the default setting.