User manual

5.0 Menu System:

5.1 Installation Menu

In this part of the manual only the basic installation is covered. If you wish to set up your

receiver to work with a motorised dish then please refer to SECTION 6, “Advanced Instal-

lation”. The MENU provides access to many features and functions which will help to

improve your enjoyment of your new product. Press MENU to enter the INSTALLATION

Menu, then use the CH-, CH+ keys to select the item you wish to adjust and the VOL-,

VOL+ to select the new setting. Then press OK to store.

5.1.1 Selecting your Satellite

Use this option within the ANTENNA SETTING menu to select your desired Satellite.

NOTE: If you change the selected Satellite you may need to re-adjust your dish.

5.1.2 Selecting your SCAN Mode

Select the Scanning mode of your chosen satellite; FTA only, ALL, FTA+NIT or ALL+NIT.

FTA only: To Search for all the Free Channels available with the selected satellite or

transponders.

ALL: To Search for all the Free Channels + Scrambled Channels available with the

selected Satellite or Transponders.

FTA + NIT: To Search for all the Free Channels available with the selected Satellite or

Transponders including the new transponders that are not pre-programmed in your set

top box but broadcasted by the Satellite Stream.

ALL + NIT: To Search for ALL Channels available with the selected Satellite or

Transponders including the new transponders that are not pre-programmed in your set

top box but broadcasted by the Satellite Stream.

NOTE: Changing this setting from, for example, ALL to FTA or FTA+NIT will

reduce the number of Programmes stored as it will remove encrypted

programmes. This will make the task of editing / sorting programmes easier.

5.2 Channel Edit Menu

This section describes how you can edit your programmes. To enter the CHANNEL EDIT

menu, press MENU and then VOL+ and OK