Fiber
Ordering Information
Fiber | openGear
®
p.87
Multiplexing/De-Multiplexing
FCM-6844 4 CH Optical MUX w/ Expansion Port
FCD-6845 4 CH Optical DEMUX w/ Expansion Port
FCM-6846 8 CH Optical MUX
FCD-6847 8 CH Optical DEMUX
FCM-6848 8 CH Optical MUX w/ Expansion Port
FCD-6849 8 CH Optical DEMUX w/ Expansion Port
CWDMOpticalMUX/DEMUX
Three sets of MUX / DEMUX modules are available: a 4 channel with expansion port, an 8 channel, and an 8
channel with expansion port. Using individual, or a combination of modules, allow for the creation of 4, 8, 12,
or 16 channel systems. Modules with expansion ports enable the use of existing non-CWDM 1310nm lasers
to create 5, 9 and 13 channel systems.
Wavelength MUX / DEMUX modules use passive wavelength lters. The modules t the OG3-FR frame
but draw no power. With no active components, modules offer a very high level of reliability.
CWDMTransmittersandReceivers
Wave division multiplexing allows the use of multiple wavelengths of light on a single ber, therefore allowing a
single ber to carry multiple signals. Each signal can run at its own bit rate and protocol, independent for the
other signals.
Each electrical signal to be multiplexed into the nal output must be converted to an optical signal with a
unique wavelength by using different lasers on the transmitter. All Ross openGear
®
ber transmitters have
the option for CWDM output. The FDT-6604 dual electrical to optical transmitter comes in 8 product variants,
utilizing DFB optical SFPs, with each card transmitting two neighboring wavelengths. The FST-6602 single
transmitter, MUX-6258 audio mux and Ethernet products come in 16 different product variants. CWDM
products are identied by a two digit sufx, which identies the lower wavelength.
For example, dual channel products like the FDT-6604-27 will transmit 1270nm on its rst channel, and 1290nm
on its second channel. Single channel products like the MUX-6258-55 will output 1550nm.
Optical to electrical converters use a wide spectrum optical receiver, and will work with any wavelength. All
optical to electrical converters are wide spectrum receivers and will function within a CWDM system, regardless
of the transmitted wavelengths.
KeyFeatures
MUX/DEMUXFeatures
• Passive CWDM optical MUX and DEMUX modules contain
no active components and offer very high reliability
• Optical output connection: LC / UPC
• Supports single-mode ber
• Expandable from 4 or 8 to 12 or 16 channel systems
• Latching rear module to prevent accidental removal
• Fits OG3-FR frame, passive modules do not require any
power
• 5-year transferable warranty
• Power: 4.5 watts