User's Manual
Table Of Contents
- 1. Introduction
- 2. Technical Specifications
- 3. Mounting
- 4. Wiring Instructions
- 5. Reader Operation
- 6. Proximity Operation
- 7. Keypad Operation Instructions
- 7.1 Programming Menu
- 7.2 Entering Programming Mode
- 7.3 Exiting Programming Mode
- 7.4 Selecting Keypad Transmission Format
- 7.5 Keypad Transmission Format Option Number
- 7.5.1 Option 1: Single Key, Wiegand 6-Bit (Rosslare Format)
- 7.5.2 Option 2: Single Key, Wiegand 6-Bit Nibble and Parities
- 7.5.3 Option 3: Single Key, Wiegand 8-Bit Nibbles Complemented
- 7.5.4 Option 4: 4 Keys Binary + Facility Code, Wiegand 26-Bit
- 7.5.5 Option 5: 1 to 5 Keys + Facility Code, Wiegand 26-Bit
- 7.5.6 Option 6: 6 Keys BCD and Parity Bits, Wiegand 26-Bit
- 7.5.7 Option 8: 1 to 8 Keys BCD, Clock & Data
- 7.5.8 Option 9: Single Key, Wiegand 4-Bit
- 7.6 Changing the Programming Code
- 7.7 Changing the Facility Code
- 7.8 Setting the Backlight Behavior
- 7.9 Return to Factory Default Settings
- 7.10 Replacing a lost Programming Code
- 8. OSDP Operation
- A. Wiegand Output Formats
- B. Limited Warranty
Mounting
12 AY-G/H6xx0 Installation and User Manual
3. Mounting
To mount the units:
1. Determine an approximate location for the reader.
2. Peel off the back of the self-adhesive mounting label template
and place it at the required mounting location.
3. Using the template as a guide, drill two holes (sizes indicated on
the template) used for mounting the back plate onto the surface
(Figure 1).
Figure 1: Mounting
AY-GXXXX
AY-HXXXX
4. Insert a suitable wall plug into each screw hole.
5. Drill a 10-mm (7/16”) hole for the cable.
6. Screw the back plate onto the wall.
7. Connect the reader to the controller (see Chapter 4). A linear
type power supply is recommended.
8. Attach the reader to the back plate and secure the reader to the
back plate with the provided security screw and tools.