User's Manual
Table Of Contents
- 1. Introduction
- 2. Technical Specifications
- 3. Mounting
- 4. Wiring Instructions
- 5. Reader Operation
- 6. Proximity Operation
- 7. Keypad Operation Instructions
- 7.1 Programming Menu
- 7.2 Entering Programming Mode
- 7.3 Exiting Programming Mode
- 7.4 Selecting Keypad Transmission Format
- 7.5 Keypad Transmission Format Option Number
- 7.5.1 Option 1: Single Key, Wiegand 6-Bit (Rosslare Format)
- 7.5.2 Option 2: Single Key, Wiegand 6-Bit Nibble and Parities
- 7.5.3 Option 3: Single Key, Wiegand 8-Bit Nibbles Complemented
- 7.5.4 Option 4: 4 Keys Binary + Facility Code, Wiegand 26-Bit
- 7.5.5 Option 5: 1 to 5 Keys + Facility Code, Wiegand 26-Bit
- 7.5.6 Option 6: 6 Keys BCD and Parity Bits, Wiegand 26-Bit
- 7.5.7 Option 8: 1 to 8 Keys BCD, Clock & Data
- 7.5.8 Option 9: Single Key, Wiegand 4-Bit
- 7.6 Changing the Programming Code
- 7.7 Changing the Facility Code
- 7.8 Setting the Backlight Behavior
- 7.9 Return to Factory Default Settings
- 7.10 Replacing a lost Programming Code
- 8. OSDP Operation
- A. Wiegand Output Formats
- B. Limited Warranty
Reader Operation
AY-G/H6xx0 Installation and User Manual 15
5. Reader Operation
Once the reader is wired to a power supply and to the controller, you
should test the reader.
To test the reader:
1. Power up the reader.
The beeper sounds three times and the LED turns red, blue, and
green, to indicate that the reader is working properly. The LED
returns to its Standby mode (red for the AY-x6x70 series and blue
for the AY-x6x80 series).
2. Present the appropriate type of proximity card to the reader or
enter a valid keypad entry.
The reader emits a beep (0.5 seconds). The LED changes
momentarily to green and then returns to its Standby mode (red
for the AY-x6x70 series and blue for the AY-x6x80 series).
The reader transmits the card's data or the keypad entry to the
controller for validation.