User's Manual

AY-B91x0BT User Guide
10
3. Environment Setting
3.1. Terminal Setting
3.1.1. Setting via Rosslare Bio9000
 Card Format
The type of card to be used can be set.
Settings
Display Method
No Use
Do not use the card authentication
EM
Use a low-frequency (125 kHz) EM card
MIFARE
Use a high-frequency (13.56 MHz) MIFARE card
 Wiegand Output
This mode is available if the terminal is equipped with a separate controller operated by Wiegand input.
Settings
Display Method
No Use
Do not use the Wiegand communication
26Bit
Perform the Wiegand communication by a format of 26-Bit
34Bit
Perform the Wiegand communication by a format of 34-Bit
 Device Mode
If reader mode is selected, Wiegand output is Card Number when authentication is Success.
If access control is selected, Wiegand output is User’s ID when authentication is Success.
 Sitecode
Set the value of Sitecode to transfer upon Wiegand output.
If Wiegand output is 26bit, a value of 0 to 255 can be set. If Wiegand output is 34-Bit, a value
of 0 to 32767 can be set.
 Ext 485
Can select external RS-485 device.
 485 ID
Can assign ID of External RS-485 device to 0-7.
 1:N Level
When 1:N authentication, set the verification level to 5-9.
 1:1 Level
When 1:1 authentication, set the verification level to 1-9.
 Max ID Length
This indicates the length of ID which can be entered to the maximum.
 Network Mode
Set whether the terminal is used to either a standalone mode or a network mode.
 Node ID
Set the terminal ID to add to ACM Pro in the range of 1 to 2000.
 Use DHCP
Set whether to use a static IP.