User's Manual
Table Of Contents
- Table of Contents
- 1. Before Getting Started
- 2. Product Description
- 3. Environment Setting
- 4. How to Use Terminal
- 5. Troubleshooting
- 5.1. When the fingerprint authentication time is too long or fails:
- 5.2. When the fingerprint is not entered well:
- 5.3. When the RF card authentication fails:
- 5.4. When the network is not connected:
- 5.5. When the authentication is successful but the door does not open:
- 5.6. When the user is not registered:
- 5.7. When the product is unstable or does not work:
- Appendix 1. Glossary
- Appendix 2. Declaration of Conformity
- Appendix 3. Radio Equipment Directive (RED)
- Appendix 4. RoHS Directive
AY-B91x0BT User Guide
18
Appendix 2. Declaration of Conformity
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
This device may not cause harmful interference.
This device must accept any interference received, including interference that may cause
undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance could
void the user's authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
Consult the dealer or an experienced radio/TV technician for help.
CAUTION: Exposure to radio frequency radiation
This equipment should be installed and operated with a minimum distance of 20 cm between the
radiator and your body.