User's Manual

AY-B9350 User Manual 41
3.6.3. Face Recognition
▶ Default setting: same with the setting in the left
screen
▶ Face Authentication
Press the check box to enable the function.
▶ Matching Level
Level used for face authentication. It is set to 1~4
of steps according to match degree with
registered face. Match degree must be higher
than the setting authentication level for successful
authentication.
The higher the authentication level, security can
be the higher. However, since it requires relatively
high match rate, probability that failure of
authentication will be higher during self-
authentication.
▶ Face Recognition
The mode is to designate method for face authentication, and it can be set according
to use environment.
For more information on each setting method, refer to ‘1.6, correct face registration
and Authentication Method’.
▶ Camera Angle
The mode is to set the default value of camera angle for face authentication, and it
can be selected from –2 degrees to +4 degrees
▶ Enrollment sensitivity
This is to set face registration sensitivity. Default value is automatically set.
To apply the setting value, press [OK] button or press [BACK] button to cancel and to
move to the upper menu. If ‘OK’ button is pressed without changing the setting value,
directly move to upper menu.