Instruction manual

Page 42
07/04
AC-Q41H
Glossary
valid users. In this mode the door
A
may be released by anyone pressing
Access Control: Primarily refers to
the star button.
a device or set of devices controlling
C
the entry of people traveling through
a door or set of doors. Cards: See Proximity Cards
Ajar Delay: The time allowed for a Case Tamper: The electronic
door to be left open before sounding tamper signal advising the controller
an alert and / or activating the that the case has been opened.
Auxiliary Relay. Code Assignment: The process of
Amplitude Shift Keying (ASK): The assigning which Output(s) (Lock
typ e of dat a com mun ica tio ns Strike Relay and / or Auxiliary Relay)
between the Proximity Card and the are to be activated when a valid code
Proximity Reader. is entered.
ASK: An abbreviation of "Amplitude
D
Shift Keying".
Direct Shunt: The arrangement in
Auxiliary Input: The term used for
which an external input (such as a
the programmable input electrical
door monitor) is connected directly to
signal from an external device such
the Auxiliary Relay allowing the
a Door Monitor switch or Auxiliary
Auxiliary Output to be activated after
REX button.
the direct shunt delay elapses. This
Auxiliary Code: The four digit code
leaves the Auxiliary Input available
used to activate the Auxiliary Output
for Normal / Secure mode toggle.
for testing purposes during
Default Factory Setting: The
installation.
settings that the controller is
Auxiliary Output: The term used for
preprogrammed with when the
the Relay Output in the AC-Q41H
controller is manufactured.
that may be programmed to activate
Direct Shunt Delay: The delay time
upon different system events such as
(user programmed) used in Direct
Tamper, Forced Door Event, Door
Shunt (See Direct Shunt).
Ajar, etc.
Door Bell: The alert sound activated
B
when the door star button on the AC-
Back Tamper: The ele ctr oni c Q41H is pressed. (Requires the BL-
tamper signal advising the controller D40 External Sounder)
that the controller has been removed Door Chime: The alert sound
from the wall. activated when the lock strike
Bypass Code: The four digit code unlocks the door after a valid code
used to ch ange the M ode o f has been presented. (Requires the
Operation of the AC-Q41H from BL-D40 External Sounder)
Normal to Bypass Mode or vice
versa.
Bypass Mode: A Mode of Operation
where door access is not restricted to
Page 43
07/04
AC-Q41H
Replacing a lost Programming Code
1) Remove power from the
2) Press the REX button
3) Apply power to the unit with REX button pressed
4) Release the REX button
5) You now have 15 seconds to program a new Programming Code
into the unit using the initial default code 1234, before the
controller reverts to the existing code.
Replacing a lost Normal / Secure Code
1) Remove power from the AC-Q41H
2) Press the REX Button
3) Apply power to the unit with REX button pressed.
4) Release the REX Button
5) You now have 15 seconds to use the default Normal / Secure
code 3838 in order to return to normal mode, where you may
enter programming mode to program a new Normal / Secure
Code.
Note: The AC-Q41H must be in Normal Mode otherwise this
will not work. Make sure that the Mode LED is green
before proceeding.
AC-Q41H
Note: The AC-Q41H must be in Secure Mode otherwise this
will not work. Make sure that the Mode LED is red before
proceeding.