Programming Manual
Table Of Contents
- 1. Introduction
- 2. Technical Specifications
- 3. Installation
- 4. Operation
- 5. Programming
- 5.1 Entering the Programming Mode
- 5.2 Exiting the Programming Mode
- 5.3 Changing the Open Code
- 5.4 Changing the Auxiliary Code
- 5.5 Changing the Programming Code
- 5.6 Changing the Normal/Secure Code
- 5.7 Changing the Normal/Bypass Code
- 5.8 Setting Fail Safe/Secure Operation
- 5.9 Setting Auxiliary Modes
- 5.10 Setting the Lockout Feature
- 5.11 Setting the Backlight Behavior
- 5.12 Enrolling Primary and Secondary Codes
- 5.13 Deleting Primary and Secondary Codes
- 5.14 Relay Codes Assignment
- 5.15 Changing PIN Code Length/Factory Default Settings
- 5.16 Replacing a Programming Code
- 5.17 Replacing a Normal/Secure Code
- A. Declaration of Conformity
- B. Limited Warranty
Introduction
10 AC-F/G4x Series Installation and Programming Manual
All data contained herein subject to change without prior notice.
In no event shall manufacturer be liable for any special, direct,
indirect, incidental, consequential, exemplary or punitive damages
(including, without limitation, any and all damages from business
interruption, loss of profits or revenue, cost of capital or loss of use
of any property or capital or injury).
All graphics in this manual are for reference only, some deviation
between the image(s) and the actual product may occur.
All wiring diagrams are intended for reference only, the photograph
or graphic of the PCB(s) are intended for clearer illustration and
understanding of the product and may differ from the actual PCB(s).