Programming Manual
Table Of Contents
- 1. Introduction
- 2. Technical Specifications
- 3. Installation
- 4. Operation
- 5. Programming
- 5.1 Entering the Programming Mode
- 5.2 Exiting the Programming Mode
- 5.3 Changing the Open Code
- 5.4 Changing the Auxiliary Code
- 5.5 Changing the Programming Code
- 5.6 Changing the Normal/Secure Code
- 5.7 Changing the Normal/Bypass Code
- 5.8 Setting Fail Safe/Secure Operation
- 5.9 Setting Auxiliary Modes
- 5.10 Setting the Lockout Feature
- 5.11 Setting the Backlight Behavior
- 5.12 Enrolling Primary and Secondary Codes
- 5.13 Deleting Primary and Secondary Codes
- 5.14 Relay Codes Assignment
- 5.15 Changing PIN Code Length/Factory Default Settings
- 5.16 Replacing a Programming Code
- 5.17 Replacing a Normal/Secure Code
- A. Declaration of Conformity
- B. Limited Warranty
Programming
AC-F/G4x Series Installation and Programming Manual 33
5.1
Entering the Programming Mode
•
The controller must be in Normal mode to enter the
programming mode.
•
The factory default 4-digit programming code is 1234.
•
If a Programming code is not entered within 5 seconds, the
controller returns to Normal mode.
To enter Programming mode:
1.
Press # twice.
The left LED turns off and the right LED
turns red.
2.
Enter your 4-digit Programming code.
The right LED turns green.
5.2
Exiting the Programming Mode
•
Wrong entries may reset the controller back to Normal mode.
•
If no key is pressed for 1 minute, while in Programming mode,
the controller exits Programming mode and returns to Normal
mode.
To exit Programming mode:
1.
Press # twice to exit Programming mode at any time.
Red