Programming Manual
Table Of Contents
- 1. Introduction
- 2. Technical Specifications
- 3. Installation
- 4. Operation
- 5. Programming
- 5.1 Entering the Programming Mode
- 5.2 Exiting the Programming Mode
- 5.3 Changing the Open Code
- 5.4 Changing the Auxiliary Code
- 5.5 Changing the Programming Code
- 5.6 Changing the Normal/Secure Code
- 5.7 Changing the Normal/Bypass Code
- 5.8 Setting Fail Safe/Secure Operation
- 5.9 Setting Auxiliary Modes
- 5.10 Setting the Lockout Feature
- 5.11 Setting the Backlight Behavior
- 5.12 Enrolling Primary and Secondary Codes
- 5.13 Deleting Primary and Secondary Codes
- 5.14 Relay Codes Assignment
- 5.15 Changing PIN Code Length/Factory Default Settings
- 5.16 Replacing a Programming Code
- 5.17 Replacing a Normal/Secure Code
- A. Declaration of Conformity
- B. Limited Warranty
Programming
38 AC-F/G4x Series Installation and Programming Manual
5.6
Changing the Normal/Secure Code
•
When the Auxiliary mode is 1, 2, 3 or 4, the auxiliary input takes
priority over the Normal/Secure code.
•
Code 0000 erases and deactivates the Normal/Secure code.
To change the Normal/Secure code:
1.
Enter Programming mode.
2.
Press 4 to enter Menu 4.
The left LED flashes red.
3.
Enter the new 4-digit Normal/Secure code.
You hear three beeps.
The system returns to Normal mode.
5.7
Changing the Normal/Bypass Code
The Normal/Bypass code is also used to turn the door chime off
and on. Chime only functions with the BL-D40 external sounder.
•
The chime is only heard when the Lock Strike relay is activated
by a valid code entry.
•
Code 0000 erases and deactivates the Normal/Bypass code.
To change the Normal/Bypass code:
1.
Enter Programming mode.
Green
Green
Red
Green
Green