Programming Manual
Table Of Contents
- 1. Introduction
- 2. Technical Specifications
- 3. Installation
- 4. Operation
- 5. Programming
- 5.1 Entering the Programming Mode
- 5.2 Exiting the Programming Mode
- 5.3 Changing the Open Code
- 5.4 Changing the Auxiliary Code
- 5.5 Changing the Programming Code
- 5.6 Changing the Normal/Secure Code
- 5.7 Changing the Normal/Bypass Code
- 5.8 Setting Fail Safe/Secure Operation
- 5.9 Setting Auxiliary Modes
- 5.10 Setting the Lockout Feature
- 5.11 Setting the Backlight Behavior
- 5.12 Enrolling Primary and Secondary Codes
- 5.13 Deleting Primary and Secondary Codes
- 5.14 Relay Codes Assignment
- 5.15 Changing PIN Code Length/Factory Default Settings
- 5.16 Replacing a Programming Code
- 5.17 Replacing a Normal/Secure Code
- A. Declaration of Conformity
- B. Limited Warranty
Programming
54 AC-F/G4x Series Installation and Programming Manual
A Secondary code can be the same as the primary code of
any user.
5.12.3 Enrolling Methods
There are two methods used to enroll primary and secondary
codes: the standard method and the code search method.
The Standard Method is used when the user slot number, for
the user you wish to program, is known. You can program
both primary and secondary codes using this method.
The Code Search Method is mainly used when enrolling a
secondary code and the user’s slot code is unknown. The
code search method functions only if a user’s primary code
is already enrolled and the secondary code is not.
5.12.3.1 Enrolling Primary and Secondary Codes using the
Standard Method
To enroll Primary and Secondary codes using the Standard
method:
1.
Enter Programming mode.
2.
Press 7 to enter Menu 7.
The right LED turns orange.
3.
Enter the 3-digit user slot
number between
001and 500 for the slot to which you wish
to enroll a Primary or Secondary code.
Orange
Green