Programming Manual
Table Of Contents
- 1. Introduction
- 2. Technical Specifications
- 3. Installation
- 4. Operation
- 5. Programming
- 5.1 Entering the Programming Mode
- 5.2 Exiting the Programming Mode
- 5.3 Changing the Open Code
- 5.4 Changing the Auxiliary Code
- 5.5 Changing the Programming Code
- 5.6 Changing the Normal/Secure Code
- 5.7 Changing the Normal/Bypass Code
- 5.8 Setting Fail Safe/Secure Operation
- 5.9 Setting Auxiliary Modes
- 5.10 Setting the Lockout Feature
- 5.11 Setting the Backlight Behavior
- 5.12 Enrolling Primary and Secondary Codes
- 5.13 Deleting Primary and Secondary Codes
- 5.14 Relay Codes Assignment
- 5.15 Changing PIN Code Length/Factory Default Settings
- 5.16 Replacing a Programming Code
- 5.17 Replacing a Normal/Secure Code
- A. Declaration of Conformity
- B. Limited Warranty
Programming
AC-F/G4x Series Installation and Programming Manual 55
For example, User Slot 003 represents User #3.
If the selected slot has no Primary code,
the left LED flashes green, indicating that
the controller is ready to accept a Primary
code.
If the selected slot already has a Primary
code but no Secondary code, the left LED
flashes red, indicating that the controller is
ready to accept a Secondary code.
If the selected slot already has a Primary
and Secondary code
, you hear a long beep
and the controller returns to Normal mode.
4.
Perform one of the following:
Enter the PIN code that you want to
assign as the Primary or Secondary
code for this slot number.
Present your user card that you want to assign as the
Primary or Secondary code for this slot number.
Green
Red
Orange
Gree
Orange