Programming Manual
Table Of Contents
- 1. Introduction
- 2. Technical Specifications
- 3. Installation
- 4. Operation
- 5. Programming
- 5.1 Entering the Programming Mode
- 5.2 Exiting the Programming Mode
- 5.3 Changing the Open Code
- 5.4 Changing the Auxiliary Code
- 5.5 Changing the Programming Code
- 5.6 Changing the Normal/Secure Code
- 5.7 Changing the Normal/Bypass Code
- 5.8 Setting Fail Safe/Secure Operation
- 5.9 Setting Auxiliary Modes
- 5.10 Setting the Lockout Feature
- 5.11 Setting the Backlight Behavior
- 5.12 Enrolling Primary and Secondary Codes
- 5.13 Deleting Primary and Secondary Codes
- 5.14 Relay Codes Assignment
- 5.15 Changing PIN Code Length/Factory Default Settings
- 5.16 Replacing a Programming Code
- 5.17 Replacing a Normal/Secure Code
- A. Declaration of Conformity
- B. Limited Warranty
Programming
AC-F/G4x Series Installation and Programming Manual 31
5. Programming
•
In the Programming chapter, “code” refers to a PIN code or
proximity card depending on the unit you have.
•
When entering a PIN or presenting a proximity card is
mentioned, the meaning may vary between units.
Programming is done solely via the unit’s keypad driven
Programming Menu System. To reach the Programming Menu
System, the controller must first be placed into Programming
mode (see Section 5.1).
During the manufacturing process, certain codes and settings are
pre-programmed. These settings are the called default factory
settings.
Table 2 shows all the programming menus, with default factory
codes and settings.
Table 2: Programming Menus
Menu
No.
Description Default Section
4
Digits
5
Digits
6
Digits
4-8
Digits
1 Change Open code 2580 25802
258025
25802580
5.3
2 Change Auxiliary code 0852 08520
085208
08520852
5.4
3 Change Program code 1234 12341
123412
12341234
5.5
4 Change Normal/Secure 3838 38383
383838
38383838
5.6