Programming Manual
Table Of Contents
- 1. Introduction
- 2. Installation
- 3. Operation
- 4. Programming
- 4.1 Entering the Programming Mode
- 4.2 Exiting the Programming Mode
- 4.3 Changing the Open Code
- 4.4 Changing the Auxiliary Code
- 4.5 Changing the Programming Code
- 4.6 Changing the Normal/Secure Code
- 4.7 Changing the Normal/Bypass Code
- 4.8 Setting Fail Safe/Secure Operation, Tamper Siren and Lock Strike Release Time
- 4.9 Setting Auxiliary Modes
- 4.10 Keypad Heater Operation
- 4.11 Setting the Lockout Feature
- 4.12 Setting the Backlight Behavior
- 4.13 Enrolling Primary and Secondary Codes
- 4.14 Deleting Primary and Secondary Codes
- 4.15 Relay Codes Assignment
- 4.16 Changing PIN Code Length/Factory Default Settings
- 4.17 Replacing a Programming Code
- 4.18 Replacing a Normal/Secure Code
- 5. Technical Specifications
List of Figures
vi AC-Q4x Series Installation and Programming Manual
List of Figures
Figure 1: Front Panel ............................................................................................11
Figure 2: Drilling Holes Identification .................................................................12
Figure 3: Pre-Wired Connection for Lock Strike Relay & REX ..........................15
Figure 4: Pre-Wired Connection for Auxiliary Input & Output ...........................16
Figure 5: Pre-Wired Connection for the BL-D40 External Sounder ..................17
Figure 6: Connections to Terminal Blocks .........................................................18
Figure 7: Terminal Block Wiring of the Lock Strike Relay & REX .....................19
Figure 8: Terminal Block Wiring of the Auxiliary Input and Output .................20
Figure 9: Terminal Block Wiring of the BL-D40 External Sounder ...................21