Operation Manual

- 20 -
Assembly Instructions
NOTE;
Most of the listed assembly hardware has been packaged separately, but some hardware items have been preinstalled in the
identi ed assembly parts. In these instances, simply remove and reinstall the hardware as assembly is required.
Please reference the individual assembly steps and make note of all preinstalled hardware.
PREPARATION: Before assembling, make sure that you will have enough space around the item; Use the present tooling for
assembling; before assembling please check whether all needed parts are available.
It is strongly recommended this machine to be assembled by two or more people to avoid possible injury.
Attention:
Please follow these assembly instructions step by step to assemble this upright bike
Step 1:
Fix the Front stabilizer (3) and Rear stabilizer (4) to the Main frame
(1) with Carriage bolt (12), Arc washer (13) and Acorn nut (14)
Step 2:
Connect the Sensor wire (20) well with Extension wire (18) and then
connect the Tension cable (19) well with wire of Tension controller
(17) as shown.
Fix the Handlebar post (2) to the Main frame (1) with Allen screw
(16), Arc washer (56).