User Manual

Rostra Precision Controls, Inc. - 2519 Dana Dr. - Laurinburg, NC 28352 - 800-782-3379 - rostra.com
Page 2
System Layout
Installation
1. Remove the existing mirror from the windshield and replace with RearSight mirror
tightening the mirror’s stem to the windshield with a Phillips screwdriver. (Some vehicles
require a mirror removal tool).
2. Connect the mirror’s Red Wire to a fused Ignition 12-volt power circuit, Black Wire to a
vehicle ground point, and Green Wire to the reverse power circuit at the fuse panel or the
rear lamp.
3. Connect the video feed from your camera (not included) to the yellow female RCA camera-
in plug.
Adjusting LCD Screen Brightness
While the LCD screen built into this mirror dims automatically depending upon the light inside the
vehicle, it can also be adjusted manually. When the vehicle is shifted into reverse and the LCD
monitor is displaying the image of the area behind the vehicle, the brightness of the screen can be
adjusted by pressing the Power button on the face of the monitor.