Manual

ITEM QTY DESCRIPTION
18WIRE ZIP TIES
2
3
NOTE:
HARDWARE BAG CONTENTS
KIT CONTENTS/SERVICE PARTS
C
ONFLICTS
RECOMMENDED TOOLS
FORD FIESTA ( AT/MT)
G
ENERAL APPLICABILITY
L
EGEND
STOP: DAMAGE TO VEHICLE MAY OCCUR. DO NOT PROCEED UNTIL
PROCESS COMPLIANCE HAS BEEN MET
.
OPERA
TOR SAFETY:
U
SE CAUTION TO
A
VOID RISK OF INJURY.
CRITICAL
PROCESS: PROCEED WITH CAUTION TO ENSURE A
Q
UALITY INSTALLATION. THESE POINTS WILL BE AUDITED ON A
COMPLETED VEHICLE INSTALLATION
.
GENERAL
PROCESS: THIS HIGHLIGHTS SPECIFIC PROCESSES TO
ENSURE A QUALITY INSTALLATION
. THESE POINTS WILL BE AUDITED DURING
THE ACCESSORY INSTALLATION
.
T
OOLS & EQUIPMENT: THIS CALLS OUT THE SPECIFIC TOOLS AND
EQUIPMENT REQUIRED FOR THE PROCESS.
REVISION MARK:
THIS MARK HIGHLIGHTS A CHANGE IN
INSTALLATION WITH RESPECT TO PREVIOUS ISSUE.
PERSONAL
& VEHICLE PROTECTION
SAFETY GLASSES
SPECIAL TOOLS
VOLT
-OHM METER
INSTALLATION
TOOLS
TRIM REMOVAL TOOL PHILLIPS SCREWDRIVER
10-MM W
RENCH
DRILL BITS 9.5
MM OR 3/8” (
FOR SWITCH)
14
MM WRENCH
SOLDERING T
OOL
SPECIAL
CHEMICALS
ITEM Q
TY DESCRIPTION PART#
11C
RUISE CONTROL MODULE 250-2897
21C
LUTCH HARNESS 250-2759
31PEDAL INTERFACE HARNESS 250-2821
41DIAGNOSTICS HARNESS 250-2785
51CONTROL SWITCH 250-2867
FORM #5594, REV. A, 07-15-2015
2011- 14 FORD FIESTA / 2010 MAZDA 3
PART NUMBER: 250-9610-NS
ELECTRONIC CRUISE CONTROL KIT
WARNING: DO NOT USE HAND-HELD 2-WAY TRANSCEIVERS INSIDE YOUR VEHICLE WHILE
DRIVING.
WHEN TRANSMITTING FROM INSIDE THE CAR, 2-WAY RADIOS THAT OPERATE IN THE 25MHZ-
700MHZ FREQUENCY RANGE WITH MORE THAN 2.0 WATTS OF POWER CAN PRODUCE ELEC-
TROMAGNETIC INTERFERENCE THAT COULD INTERFERE WITH THE OPERATION OF CRUISE
AND THROTTLE CONTROLS RESULTING IN VEHICLE "LIMP MODE".
USE OF CELLULAR PHONES WILL NOT INTERFERE WITH THESE CONTROLS.
DUE TO SENSITIVE NATURE OF SIGNALS USED FOR THIS PRODUCT, ALL NON-PLUG AND
PLAY CONNECTIONS MUST BE SOLDERED. FAILURE TO COMPLY WITH THIS REQUIREMENT
WILL VOID WARRANTY.