Manual

ITEM QTY DESCRIPTION
18WIRE ZIP TIES
2
3
NOTE:
HARDWARE BAG CONTENTS
KIT CONTENTS/SERVICE PARTS
CONFLICTS
RECOMMENDED TOOLS
MAZDA 3 ( AT/MT)
GENERAL APPLICABILITY
LEGEND
STOP: DAMAGE TO VEHICLE MAY OCCUR. DO NOT PROCEED UNTIL
PROCESS COMPLIANCE HAS BEEN MET
.
OPERATOR SAFETY: USE CAUTION TO AVOID RISK OF INJURY.
CRITICAL
PROCESS: PROCEED WITH CAUTION TO ENSURE A
QUALITY INSTALLATION. THESE POINTS WILL BE AUDITED ON A
COMPLETED VEHICLE INSTALLATION.
GENERAL PROCESS: THIS HIGHLIGHTS SPECIFIC PROCESSES TO
ENSURE A QUALITY INSTALLATION
. THESE POINTS WILL BE AUDITED DURING
THE ACCESSORY INSTALLATION.
TOOLS & EQUIPMENT: THIS CALLS OUT THE SPECIFIC TOOLS AND
EQUIPMENT REQUIRED FOR THE PROCESS.
REVISION MARK:
THIS MARK HIGHLIGHTS A CHANGE IN
INSTALLATION WITH RESPECT TO PREVIOUS ISSUE.
PERSONAL & VEHICLE PROTECTION
SAFETY GLASSES
SPECIAL TOOLS
VOLT-OHM METER
INSTALLATION TOOLS
TRIM REMOVAL TOOL PHILLIPS SCREWDRIVER
10-MM WRENCH
DRILL BITS 9.5MM OR 3/8” (FOR SWITCH)
14
MM WRENCH
SOLDERING TOOL
SPECIAL CHEMICALS
ITEM QTY DESCRIPTION PART#
11C
RUISE CONTROL MODULE 250-2897
21DIAGNOSTICS HARNESS 250-2783
31P
EDAL INTERFACE HARNESS 250-2814
41CLUTCH HARNESS 250-2759
51CONTROL SWITCH 250-2867
FORM #5571 REV A 07-15-2015
MAZDA 3 2011-
PART NUMBER: 250-9622-NS
ELECTRONIC CRUISE CONTROL KIT
WARNING: DO NOT USE HAND-HELD 2-WAY TRANSCEIVERS INSIDE YOUR VEHICLE WHILE
DRIVING.
WHEN TRANSMITTING FROM INSIDE THE CAR, 2-WAY RADIOS THAT OPERATE IN THE 25MHZ-
700MHZ FREQUENCY RANGE WITH MORE THAN 2.0 WATTS OF POWER CAN PRODUCE ELEC-
TROMAGNETIC INTERFERENCE THAT COULD INTERFERE WITH THE OPERATION OF CRUISE
AND THROTTLE CONTROLS RESULTING IN VEHICLE "LIMP MODE".
USE OF CELLULAR PHONES WILL NOT INTERFERE WITH THESE CONTROLS.
DUE TO SENSITIVE NATURE OF SIGNALS USED FOR THIS PRODUCT, ALL NON-PLUG AND
PLAY CONNECTIONS MUST BE SOLDERED. FAILURE TO COMPLY WITH THIS REQUIREMENT
WILL VOID WARRANTY.