Owner's Manual

R1 6.5" / 8" Speaker Installation Instructions www.roswellmarine.com
PACKAGE CONTENTS
@
~
i
@
~
8
A
B C
D E
x2
x2
x1
x8
x1
R1 Series Locking Cut out
Hex-head
3mm
stainless
hex-head
Speakers trim rings template
screws bit
PREPARATION
For safety, turn off the audio system and battery switch prior to beginning installation.
If your vessel does not have a battery switch, simply disconnect the negative lead
from the battery terminal.
Use extreme caution before cutting and drilling holes to avoid damaging fuel lines,
hydraulic lines, or existing electrical components.
If additional wiring is required, we recommend using at least 18 gauge wiring and
running all wires prior to installing the speaker. Longer runs may require 16 gauge
wire to prevent negative impacts on sound quality. Leave some slack in the wire to
allow for easier installation and to prevent tension on the wire.
· Avoid running wires near sharp edged surfaces. Never run wires exposed on the
deck, protecting the wires behind cover offers the best protection from marine
elements. If wires must be routed through metal or fiberglass walls, use rubber
grommets to protect the wire.
• All wiring should be done by a qualified marine technician.
NOTE: Consider how you would Like to use the integrated RGB LED before you
begin installation. It can either be hard-wired to one of 7 different colors OR you
may purchase an LED controller to allow any combination of colors and patterns.
& WARNING &
These speakers are capable of easily producing sound
pressure levels (SPU in excess of 100 dB, even in an open-air
environment like a boat. Sound pressures at or above these
levels can easily cause permanent hearing damage or loss.
Be sure to use safe listening practices and protect your ears.
1---------------- ROSWEL.L.