Owner's Manual

R1 6.5" / 8" Speaker Installation Instructions www.roswellmarine.com
--=i::c:::=J
~
~
~
Remove the trim ring from the speaker first {refer to step G, turning in a
counterclockwise direction instead). Place the speaker into the mounting cutout
to ensure it will fit. Remove additional material if needed. Once th~ speaker fits
properly, align the speaker to the desired orientation and use a center punch or
pencil to mark the mounting holes for the screws to secure the speaker. Remove
speaker from cutout and drill the holes with a 1/8" drill bit.
-: --~
-------- -- ~~ .
~~~~ · ,,,\ - --- ~
~ - - ~ - \ \
1) 2)
NOTE: If drilling through fiberglass/gelcoat. be sure to run the drill in reverse until you
are through the gelcoat. switch the drill into forward and finish drilling as normal Then
come back with a countersink bit and remove the gelcoat surrounding the hole. This
will help avoid cracking/damaging the gelcoat around the mounting location.
Make all connections from the flying lead harness to your in-boat wiring.
flying lead
connection
I
I
in-boat wiring
If you are not using the OEM quick-connect option, the wires may be cut and
crimped as follows:
1)
Cut line--,
Pin Wire
Function
µ~
Location Color
1 White Speaker+
2 White/ Speaker-
Black
2)
Strip 5/16" of wires and connect
Black LED12V+
to boat wiring using 18 AWG (Red)
3
Heat Shrink Butt Splices
Red Red LED-
4
OI:=:1D
l 5115· l :
I
5
Green Green LED -
I
I
butt splice in-boat wiring
6 Blue
Blue LED-
,___ _____________ R.OSWEL.L.