Owner's Manual

Rl 6.5" Tower Speaker Installation Instructions
www.roswellmarine.com
Wiring options for RGB LEDs
Before starting assembly you will need to consider the LED config-
uration you would like to use .. You can wire the RGB LEDs in your
speakers to be either one fixed color, or your can wire them to be
used with the Roswell RGB Controller {Part Num. C920-1620).
Connecting the wires on the speaker wiring harness in different
configurations will produce different colors. See the table below to
select your color if you are not using the RGB
Controller. If using the RGB controller you will need to
run a total of four wires to connect to the controller in
the boat's hull, which means even if you have a
pre-wired tower it is very likely you will need to add
wires to your tower.
Speaker Wiring Harness
Blue
Blue LED(-)
Green
Green LED (-)
Red
Red LED(-)
White
Yellow
Black
Wiring Configuration
Blue -- ct=:1D-12v (-)
Green -- ct=:1D-12V (-)
Red --- ct=:1D -12V (-)
Green -(7-""ff\ - l lV (-)
Red--1..1---ll/
Output
Blue
Green
Red
Yellow
t------------t------f
Blue-=====-ct=l] _
1
lV (- )
Red
Blue ---- (7-""ff\ _
1
lV (-)
Green--~
Blue~
Green (l=t]-12v (-)
Red
Magenta
Cyan
White
Blue --- et:=(D Blue 12V(-) Cootrollable /
Green-- et:=(DGreen 12V (-) Programmable
Red--- et:=(DRed 12V(-) RGB
Speaker(+) et==1] Speaker(+)
Speaker(-) et==1] Speaker(-)
LED 12V (+) et==l] LED 12V (+)
Crimp
Connector
Tower Wiring
Optional - For use with RGB Controller
1NH ••••••••••••••• ■
Optional - For use with RGB Controller
1NH ••••••• ■••••••••
12V (-)
Remove the plugs to access the wires. Carefully pull the
wires out of the tower.
-
-
Carefully cut the first piece of shrink wrap with a utility
knife to expose all of the wires and remove the plug.
Be very cautious not to cut through the wire's
insulation.
Illustrated assembly on Roswell Aviato r Tower
Note: Avia tor is no t pre - wired fo r RGB co nt roller
', shrink wrap
01-------------------- i-<OSWf L.L.
)