r
Rl 8" Tower Speaker Installation Instructions www.roswellmarine.com i-
Rl s· Tower Speaker Installation Instructions www.roswellmarine.com PACKAGE CONTENTS . (g) © g ~ij . x2 (x2) Rl 8" Tower Speakers (x2) (x2) Wiring Safety Harness Lanyard x4 x12 TOOLS &·SUPPLIES NEEDED , r r~ 3/32' Allen Key 5/ 16' Allen Key ~ Torque ~; i::: 8 "'0~ ~ .,. ! Heat Gun ~; i::: g "'0~ ~ ...
Rl 8" Tower Speaker Installation Instructions · ·• ' , www.roswellmarinc.com Wiring options for RGB LEDs Before starting assembly you will need to consider the LED configuration you would like to use.. You can wire the RGB LEDs in your sp.:akers to be either one fixed color, or your can wire them to be used with the Roswell RGB Controller (Part Num. C920-1620). Connecting the wires on the speaker wiring harness in different configurations will produce different colors.
Rl 8" Tower Speaker Installation Instructions www.roswellmarine.com 1) Use wire strippers to expose 1/4" of wire on all wires. 2) Connect the tower wires to the speaker wiring harness according to the LED configuration you plan to use. 3) Heat shrink the connectors. 4) Carefully push the wires back into the tubing. --------- Tower Wires rte1/lli[/.. i·,,; L"'f --------- Connectors k x2 < ------ ------ Speaker Harness □ ~ ~ x1 2 or x8 • -- ---------- -· Deutsch Connector \ Determine your mount
Rl 8" Tower Speaker Installation Instructions www .roswel lmarir:e .com 1. Remove the two 3/Sn-16 bolts from the clamp top. . i.,BQt~te ,the top half of the clamp open .and remove the two plastic clamp inserts from the clamp. tt r 5/16" 1. Remove the four 3/Bn-16 bolts from inside the speaker can. 2. Lift the clamp angle adapter out of the clamp, rotate the clamp to your required angle for installation 3.
Rl 8" Tower Speaker Installation Instructions Measure the tubing you will be mounting . your speakers to and select the appropriate plastic insert for your tubing diameter. Place your plastic insert into the clamp www.roswellmarine.com ' 1. Remove the safety lanyard from the speaker can. 2. Wrap the safety lanyard around the tower tube you will be mounting your speaker to and thread the lanyard through its loop on the end to make a self tightening loop. 3. Re-attach the safetly lanyard to the speaker.
Rl 8" Tower Speaker Installation Instructions www.roswellmarir,e.com Plug in both speakers Install the 5/8"-l l clamp set screws with red thread lock to secure the clamps into place. 3"tubes use the l /2." long set screw. Tubes smaller than 3.O"use the 13/16" long set screw. Note: This set screw will leave a mark on your tower when it is tightened. x2 OR x2 RED I ' ~ ' r,no·® 00 s,a·-11 x s,a·-11 x s,a·-11 x 13/16.
Rl 8" Tower Speaker Installation Instructions www.roswellmarine.com Roswell Limited Warranty ' Roswell warrants all new Rl Series Tower Speakers against defects in material and workmanship for a period ofTWO (2) YEARS from the original date of purchase. This warranty is not transferable and applies only to the original retail purchaser from an authorized Roswell retailer.
