Owner's Manual

Rl 8" Tower Speaker Installation Instructions
www.roswellmarinc.com
·• '
· , Wiring options for RGB LEDs
Before starting assembly you will need to consider the LED config-
uration you would like to use .. You can wire the RGB LEDs in your
sp.:akers to be either one fixed color, or your can wire them to be
used with the Roswell RGB Controller (Part Num. C920-1620).
Connecting the wires on the speaker wiring harness in different
configurations will produce different colors. See the table below to
select your color if you are not using the RGB
Controller. If using the RGB controller you will need to
run a total of four wires to connect to the controller in
the boat's hull, which means even if you have a
pre-wired tower it is very likely you will need to add
wires to your tower .
Speaker Wiring Harness
Blue
Blue LED(-)
Green
Green LED (-)
Red
Red LED(-)
White
Yellow
Black
Wiring Conf.guration
Blue -- cc=r:D- 12V (-)
Green ·-- cc=r:D- 12V (-)
Red --- cc=r:D- 12V (-)
Green --rr---111 _ l 2V (-)
Red --ll---UI
Output
Blue
Green
Red
Yell ow
------------+----~
Blue..:::::::==- Ct=1D _
1
2V (-)
Red
Blue:::::::=-- ct=l] _
1
lV (-J
Green
Blue~
Green cc=r:D- 12V ( -)
Red
Blue --- (J::::l] Blue 12V(-)
Green-- (J::::l]Green 12V( -)
Red --- (J::::l] Red 12V (-J
Magenta
White
Controllable /
Programmable
RGB
Speaker(+) ct=:::1] Speaker(+)
Speaker (-) ct=={] Speaker(-)
LED12V(+lct=:::l] LED12V(+)
Crimp
Connector
Tower Wiring
Optional - For ui.e with RGB Controller
12VH ••••••••••••••••
Optional - For use with RGB Controller
12VH ••••••••••••••••
12V (-)
Remove the plug to access the wires. Carefully pull the
wires out of the tqy.er.
-
-
Carefully cut the first piece of shrink wrap with a utility
knife to expose all of the wires and remove the plug.
Be very cautious not to cut through the wire's
insulation.
11/u srro, ed as sembly on Roswell Av ,a rcr Tc,wer
N ore : Aviaror ,s nor pre-wi red for RGB c onrro//er
', shrink wrap
4 ,__ __________________ ROSU.If L.L.