Owner's Manual
R1
6.5x6.5"
Vamp
Spin Speaker
Installation
Instructions
www.roswellmarine.com
Remove
the
#6 tapping screw, washer and safety
lanyard from
the
speaker. Set these aside for later.
Connect
the
included wiring harness
to
the wiring on your
tower/boat.
1)
Use
wire strippers
to
expose 1/4"
of
wire on all wires.
2) Connect
the
tower
wires
to
the
speaker wiring harness
according
to
the
LED
configuration you plan
to
use.
3) Heat shrink
the
connectors.
4) Carefully push
the
wires back
into
the
tubing.
x2
<
□
se:
x12,
or
x8
Remove
the
2 screws from each clamp and insert
the
appropriate plastic insert for your
tube
size.
Note:
If
your tubing
is
a
size
not
included in the package please
contact Roswell for other inserts. Available
sizes:
2.85'; 2.50" and
2.25"
•
Determine your
mounting
location on your
tower
and note
the
tubing
size
for
that
location. Roughly
check
to
estimate speaker clearance in this location.
3.5"
clearance for
spin speaker
------------
Speaker Harness
--------------
Deutsch Connector
Remove
the
4 set screws
that
hold each clamp
to
the
speaker. Add a
drop
of
red Loctite
into
each set
screw hole and reinsert
the
set screws
into
the
holes enough
to
hold
the
clamp
but
still loose
enough
to
be able
to
adjust the angle.
'
1111/-~--~~::::i::i:::,;n
.ll""---11
1------,
5i,-------------------------------
i-<OSUJf
L.L.