Owner's Manual
R1 Amp Installation Instructions
www.roswellmarine.com
12
To protect the power wires, connect an in-line fuse holder to the power cable as close to the
battery as possible. If one amplier is being used, refer to the table below for recommended
fuse rating. If two or more ampliers are being used, verify the fuse and wire are capable of
handling the total current load of all ampliers connected. The ampliers themselves are
internally fused and do not require additional protection.
Run a 4 AWG wire from the battery to the amplier.
Plan this part of the installation carefully.
This cable will carry a very high current . If it should short
to any metal and is not properly fused it could catch re.
Disconnect the positive cable from the boat battery.
Tape up the end so it is isolated from the battery.
x1
A B
Run the black 4 AWG ground wire directly to the
negative (-12V) pole on the battery. This wire should
handle the load in the previous step and be as short
as possible.
D
Wire your speakers and route wires to your amp
mounting location. Using the allen key, connect the
speaker wires to the amplier. Be sure to note the
wire polarity.
E
C
+ -
+ -
Fuse
100A
100A
1000.1
Amp
900.6
60A650.4
+ -
2mm
(650.4 &
900.6)
4mm
(1000.1)