Owner's Manual
R1 Amp Installation Instructions
www.roswellmarine.com
13
Remove control panel cover with a 3mm allen wrench. Adjust amplier settings to provide
appropriate power to the speakers. Replace cover when complete.
Turn on the amplier to verify it is wired correctly and
does not go into protection mode. The power LED
should turn solid blue after a few seconds.
Run a wire from the head unit remote turn-on wire
(typically blue or blue w/ white stripe) to the “REM”
terminal of the amplier.
F G
H
To Head unit
or switch
You must now set the controls on the amplier.
This is the most important part of amplier installation and should be completed by a trained audio professional.
Lights up
3mm