Owners Manual
Table Of Contents
- Introduction
- Key Features
- Battery Installation
- Overview
- IR Emitter/Sensor 
- LCD Display 
- Light Button 
- Folding Cover 
- Device/Input Buttons 
- EXT Button 
- Basic Command Buttons 
- Secondary Command Buttons 
- Multi-Step Buttons 
- Setup Button 
- Operating the RR‑1060
- Sending IR Commands   
- Smart Macro Commands   
- Multi-Step Button Operation 
- Backlighting 
- Programming
- Programming Rotel components by Model Search     
- Programming by Brand Name     
- Programming by 4-Digit Code     
- Programming by Auto-Search       
- Learning Commands From Another Remote
- Learning Commands     
- Multi-Step Button Learning 
- Smart Macro Programming
- Smart Macro Programming     
- Clearing a Smart Macro    
- Changing a Smart Macro    
- Clearing learned commands
- Clearing a Single Learned Command     
- Clearing a All Learned Commands for a DEVICE/INPUT Button   
- Clearing a All Learned Commands for ALL DEVICE/INPUT Buttons  
- Custom Labels
- Switching between two pages of labels  
- Editing DEVICE/INPUT button labels   
- Editing COMMAND button labels   
- Changing Smart Macro labels   
- Additional Setup Options
- Volume Punch-Through  
- Disabling the Beep Tone  
- Clone Function  
- Restore Factory Defaults  
17
Programming
The RR-1060 contains hundreds of command sets
for components. Programming the remote involves
selecting the command sets that correspond to
the components in your system and assigning
each of them to one of the nine DEVICE buttons
by entering the 4-digit code for that component.
This need only be done once during initial setup
of the RR-1060.
There are four ways of finding the correct 4-digit
code. The easiest way to program Rotel compo-
nents is to search by the model number. For other
components, you can search the database by the
brand name of your component. A third option
is to try the codes available for your brand from
the list of 4-digit codes. Finally, you can search
the database for ALL codes, until you find one
that works.
NOTE: Programming the RR-1060 is done in a
menu-driven setup mode accessed by pressing
the SETUP button, then using the UP/DOWN and
+/– cursor keys to navigate menus, and pressing
the ENT button to confirm selections. At any time
during the process, you can exit the setup mode
and return to normal operation by pressing the
SETUP button.
Programming Rotel components
by Model Search
You can find the correct 4-digit code for Rotel
components by searching the database for the
model number of your Rotel Audio, DVD, or CD
component.
When using the model search,
the DEVICE/IN-
PUT buttons can only be programmed for specific
types of components as follows:
AUD: Audio components only
CD: CD players only
TUN: Audio, DVD, CD only
TAPE: Audio, DVD, CD only
V1: DVD only
V2: Audio, DVD, CD only
V3: Audio, DVD, CD only
V4: Audio, DVD, CD only
V5: Audio, DVD, CD only