Owners Manual
Table Of Contents
- Introduction
- Key Features
- Battery Installation
- Overview
- IR Emitter/Sensor 
- LCD Display 
- Light Button 
- Folding Cover 
- Device/Input Buttons 
- EXT Button 
- Basic Command Buttons 
- Secondary Command Buttons 
- Multi-Step Buttons 
- Setup Button 
- Operating the RR‑1060
- Sending IR Commands   
- Smart Macro Commands   
- Multi-Step Button Operation 
- Backlighting 
- Programming
- Programming Rotel components by Model Search     
- Programming by Brand Name     
- Programming by 4-Digit Code     
- Programming by Auto-Search       
- Learning Commands From Another Remote
- Learning Commands     
- Multi-Step Button Learning 
- Smart Macro Programming
- Smart Macro Programming     
- Clearing a Smart Macro    
- Changing a Smart Macro    
- Clearing learned commands
- Clearing a Single Learned Command     
- Clearing a All Learned Commands for a DEVICE/INPUT Button   
- Clearing a All Learned Commands for ALL DEVICE/INPUT Buttons  
- Custom Labels
- Switching between two pages of labels  
- Editing DEVICE/INPUT button labels   
- Editing COMMAND button labels   
- Changing Smart Macro labels   
- Additional Setup Options
- Volume Punch-Through  
- Disabling the Beep Tone  
- Clone Function  
- Restore Factory Defaults  
25
Clearing a Smart Macro
To clear a previously saved Smart Macro:
1. Press the SETUP button and then press the UP/
DOWN cursor buttons until SMART appears
in the display. Press ENT.
2. Press the UP/DOWN cursor buttons until
SMART CLEAR appears in the display. Press
the ENT button to confirm. CLEAR SMART?
appears in the display.
3. Press the Smart Macro button to be cleared
(for example, press 1 to clear a Smart Macro
stored in the 1 button).
4. A confirmation appears in the LCD. Use the
UP/DOWN buttons to select YES (to clear
the Smart Macro) or NO (to keep the Smart
Macro). Press the ENT button to confirm.
NOTE: If you attempt to clear unprogrammed Smart
Macro button, the word EMPTY appears and the
remote returns to normal mode.
Changing a Smart Macro
To change a previously saved Smart Macro:
1. Press the SETUP button. Then, press the UP/
DOWN cursor buttons until SMART appears
in the display. Press ENT.
2. Press the UP/DOWN cursor buttons until
SMART EDIT appears in the display. Press the
ENT button to confirm. EDIT SMART? appears
in the display
3. Press the Smart Macro button to be changed
(for example, press 1 to change a Smart Mac-
ro stored in the 1 button).
4. Use the UP/DOWN buttons to select the STEP
# you wish to change, for example STEP 10.
Press the ENT button to confirm.
5. When the CHG TO ? prompt appears, press
the new command button for that step.
6. Repeat steps 5 and 6 to change any other
commands, then press the SETUP button.