Owners Manual
Table Of Contents
- Introduction
- Key Features
- Battery Installation
- Overview
- IR Emitter/Sensor 
- LCD Display 
- Light Button 
- Folding Cover 
- Device/Input Buttons 
- EXT Button 
- Basic Command Buttons 
- Secondary Command Buttons 
- Multi-Step Buttons 
- Setup Button 
- Operating the RR‑1060
- Sending IR Commands   
- Smart Macro Commands   
- Multi-Step Button Operation 
- Backlighting 
- Programming
- Programming Rotel components by Model Search     
- Programming by Brand Name     
- Programming by 4-Digit Code     
- Programming by Auto-Search       
- Learning Commands From Another Remote
- Learning Commands     
- Multi-Step Button Learning 
- Smart Macro Programming
- Smart Macro Programming     
- Clearing a Smart Macro    
- Changing a Smart Macro    
- Clearing learned commands
- Clearing a Single Learned Command     
- Clearing a All Learned Commands for a DEVICE/INPUT Button   
- Clearing a All Learned Commands for ALL DEVICE/INPUT Buttons  
- Custom Labels
- Switching between two pages of labels  
- Editing DEVICE/INPUT button labels   
- Editing COMMAND button labels   
- Changing Smart Macro labels   
- Additional Setup Options
- Volume Punch-Through  
- Disabling the Beep Tone  
- Clone Function  
- Restore Factory Defaults  
28 RR-1060
Editing DEVICE/INPUT
button labels
To change the label for a button, make sure that
you have selected the Page 2 set of labels (see
above), then:
1. Press the SETUP button.
2. Press the UP/DOWN cursor buttons until EDIT
appears in the display. Press the ENT button
to confirm.
3. Press the UP/DOWN cursor buttons until EDIT
DEVICE appears in the display. Press the ENT
button to confirm.
4. Press the DEVICE/INPUT button (AUD, CD,
TUN, TAPE, EXT, V1–V5) that you wish to re-
label. The current label appears on the sec-
ond line of the display.
5. Press the +/– buttons to select a letter in the
label to change and the UP/DOWN cursor
buttons to change the letter. The Character
Map illustration shows the available charac-
ters. Labels can be up to 8 characters.
6. When the new label is complete, press the
SETUP button to save the new label.
7. A confirmation message appears in the LCD.
Use the UP/DOWN buttons to select either
YES (to confirm the new label) or NO (to exit
without making any changes). Press the ENT
button to confirm the selection.
Editing COMMAND button labels
To change the label for a button, make sure that you
have selected the Page 2 set of labels, then:
1. Press the DEVICE/INPUT button (AUD, CD,
TUN, TAPE, V1–V5) containing the COM-
MAND button you wish to relabel.
2. Press the SETUP button.
3. Press the UP/DOWN cursor buttons until EDIT
appears in the display. Press the ENT button
to confirm.
4. Press the UP/DOWN cursor buttons until EDIT
KEY appears in the display. Press the ENT but-
ton to confirm.