Owners Manual
Table Of Contents
- Introduction
- Key Features
- Battery Installation
- Overview
- IR Emitter/Sensor 
- LCD Display 
- Light Button 
- Folding Cover 
- Device/Input Buttons 
- EXT Button 
- Basic Command Buttons 
- Secondary Command Buttons 
- Multi-Step Buttons 
- Setup Button 
- Operating the RR‑1060
- Sending IR Commands   
- Smart Macro Commands   
- Multi-Step Button Operation 
- Backlighting 
- Programming
- Programming Rotel components by Model Search     
- Programming by Brand Name     
- Programming by 4-Digit Code     
- Programming by Auto-Search       
- Learning Commands From Another Remote
- Learning Commands     
- Multi-Step Button Learning 
- Smart Macro Programming
- Smart Macro Programming     
- Clearing a Smart Macro    
- Changing a Smart Macro    
- Clearing learned commands
- Clearing a Single Learned Command     
- Clearing a All Learned Commands for a DEVICE/INPUT Button   
- Clearing a All Learned Commands for ALL DEVICE/INPUT Buttons  
- Custom Labels
- Switching between two pages of labels  
- Editing DEVICE/INPUT button labels   
- Editing COMMAND button labels   
- Changing Smart Macro labels   
- Additional Setup Options
- Volume Punch-Through  
- Disabling the Beep Tone  
- Clone Function  
- Restore Factory Defaults  
29
5. Press the COMMAND button that you wish
to relabel. The current label appears on the
second line of the display.
6. Press the +/– buttons to select a character to
change and the UP/DOWN cursor buttons to
change the letter. The “Character Map” illus-
tration shows the available characters. Labels
can be a maximum of 8 characters.
7. When the new label is complete, press the
SETUP button to save the new label.
8. A confirmation message appears in the LCD.
Use the UP/DOWN buttons to select either
YES (to confirm the new label) or NO (to exit
without making any changes). Press the ENT
button to confirm the selection.
Changing Smart Macro labels
To change the label for a Smart Macro:
1. Press the SETUP button.
2. Press the UP/DOWN cursor buttons until
SMART appears in the display. Press the ENT
button to confirm.
3. Press the UP/DOWN cursor buttons until
SMART RENAME appears in the display.
Press the ENT button to confirm.
4. Press the Smart Macro button that you wish
to relabel. The current label appears on the
second line of the display. If the button does
not have a Smart Macro programmed, the
word EMPTY appears in the display.
5. Press the +/– buttons to select a character to
change and the UP/DOWN cursor buttons to
change the letter. The “Character Map” illus-
tration shows the available characters. Labels
can be a maximum of 8 characters.
6. When the new label is complete, press the
SETUP button to save the new label.
7. A confirmation message appears in the LCD.
Use the UP/DOWN buttons to select either
YES (to confirm the new label) or NO (to exit
without making any changes). Press the ENT
button to confirm the selection.