Owners Manual
Table Of Contents
- Introduction
- Key Features
- Battery Installation
- Overview
- IR Emitter/Sensor 
- LCD Display 
- Light Button 
- Folding Cover 
- Device/Input Buttons 
- EXT Button 
- Basic Command Buttons 
- Secondary Command Buttons 
- Multi-Step Buttons 
- Setup Button 
- Operating the RR‑1060
- Sending IR Commands   
- Smart Macro Commands   
- Multi-Step Button Operation 
- Backlighting 
- Programming
- Programming Rotel components by Model Search     
- Programming by Brand Name     
- Programming by 4-Digit Code     
- Programming by Auto-Search       
- Learning Commands From Another Remote
- Learning Commands     
- Multi-Step Button Learning 
- Smart Macro Programming
- Smart Macro Programming     
- Clearing a Smart Macro    
- Changing a Smart Macro    
- Clearing learned commands
- Clearing a Single Learned Command     
- Clearing a All Learned Commands for a DEVICE/INPUT Button   
- Clearing a All Learned Commands for ALL DEVICE/INPUT Buttons  
- Custom Labels
- Switching between two pages of labels  
- Editing DEVICE/INPUT button labels   
- Editing COMMAND button labels   
- Changing Smart Macro labels   
- Additional Setup Options
- Volume Punch-Through  
- Disabling the Beep Tone  
- Clone Function  
- Restore Factory Defaults  
31
Disabling the Beep Tone
As shipped from the factory, the RR-1060 beeps
as confirmation whenever a button is pressed. This
feature can be disabled or enabled as follows:
1. Press the SETUP button (the LCD displays SET-
UP).
2. Press the UP/DOWN cursor buttons until BEEP
SOUND appears in the display. Press the ENT
button to confirm.
3. Press the UP/DOWN cursor buttons until BEEP
ON or BEEP OFF appears in the display. Press
the ENT button to select the desired option.
Clone Function
The CLONE function transfers all programming,
learned commands, labels, and settings from one
RR-1060 to a second RR-1060. To transfer the
programming, place two RR-1060 remotes with
their IR windows facing each other about 2 to 3
inches apart, then proceed as follows.
On the remote that will be receiving
the data:
1. Press the SETUP button.
2. Press the UP/DOWN cursor buttons until
CLONE appears in the display. Press the ENT
button to confirm.
3. Press the UP/DOWN cursor buttons until RE-
CEIVE appears in the display. Press the ENT
button.
On the remote that will be sending the
data:
1. Press the SETUP button (the LCD displays SET-
UP).
2. Press the UP/DOWN cursor buttons until
CLONE appears in the display. Press the ENT
button to confirm.
3. Press the UP/DOWN cursor buttons until
SEND appears in the display. Press the ENT
button.