Owners Manual
Table Of Contents
- Introduction
- Key Features
- Battery Installation
- Overview
- IR Emitter/Sensor 
- LCD Display 
- Light Button 
- Folding Cover 
- Device/Input Buttons 
- EXT Button 
- Basic Command Buttons 
- Secondary Command Buttons 
- Multi-Step Buttons 
- Setup Button 
- Operating the RR‑1060
- Sending IR Commands   
- Smart Macro Commands   
- Multi-Step Button Operation 
- Backlighting 
- Programming
- Programming Rotel components by Model Search     
- Programming by Brand Name     
- Programming by 4-Digit Code     
- Programming by Auto-Search       
- Learning Commands From Another Remote
- Learning Commands     
- Multi-Step Button Learning 
- Smart Macro Programming
- Smart Macro Programming     
- Clearing a Smart Macro    
- Changing a Smart Macro    
- Clearing learned commands
- Clearing a Single Learned Command     
- Clearing a All Learned Commands for a DEVICE/INPUT Button   
- Clearing a All Learned Commands for ALL DEVICE/INPUT Buttons  
- Custom Labels
- Switching between two pages of labels  
- Editing DEVICE/INPUT button labels   
- Editing COMMAND button labels   
- Changing Smart Macro labels   
- Additional Setup Options
- Volume Punch-Through  
- Disabling the Beep Tone  
- Clone Function  
- Restore Factory Defaults  
32 RR-1060
The data transfer begins. The sending remote dis-
plays SENDING DATA. The receiving remote dis-
plays RECEIVING DATA. At the completion of the
data transfer (which may take 4 or 5 minutes), one
of the following confirmation messages appears
in the display of the receiving RR-1060:
• If the data transfer is successful, the SEND
OK prompt appears on the sending remote
and RECEIVE OK appears on the receiving
remote.
• If the data transfer is not successful, ERROR ap-
pears in the LCD on the receiving remote. and
the unit reverts to normal operating mode.
After 30 seconds or when any button is pressed,
the remotes return to normal operation.
NOTE: Do not attempt to use the CLONE function to
transfer data from any remote other than another
Rotel RR-1060.
Restore Factory Defaults
You can restore the RR-1060 to the factory default
configuration with a simple procedure described
below. Restoring the factory configuration restores
all of the preset code sets for DEVICE/INPUT
buttons, clears all learned commands, restores
all factory labels, restores the factory punch-thru
settings, and turns the beep tone on.
1. Press the SETUP button.
2. Press the UP/DOWN cursor buttons until DE-
FAULT SETTING appears in the display. Press
the ENT button to confirm.
3. A confirmation message appears in the LCD.
Use the UP/DOWN buttons to select either
RESET YES (to restore the factory defaults) or
RESET NO (to exit without making any chang-
es). Press the ENT button to confirm the selec-
tion.
4. In a few seconds, a RESET OK prompt in the
LCD will confirm the restoring of factory de-
faults.
NOTE: Smart Macros are not reset by restoring
factory defaults. Use the Clearing a Smart Macro
instructions to delete stored Smart Macros.