Owners Manual

19English
Programming by Auto-Search
56789-q
To search for a code from the full list of available
4-digit codes for a type of component:
1. Press the DEVICE/INPUT button where you
wish to program this component’s codes (AUD,
CD, TUN, TAPE and V1–V5).
2. Press the SETUP button (the LCD displays SET-
UP). Press the ENT button to confi rm.
3. Press the UP/DOWN cursor buttons until SET-
UP A. SEARCH appears in the display. Press
the ENT button to confi rm.
4. Press the UP/DOWN cursor buttons until the
type of component you are searching for ap-
pears in the display (TV, VCR, SAT, CTV, DVD,
CD, etc.) Press the ENT button to confi rm.
5. Press and release the POWER ON button to
advance to the next code.
6. Test the code by pressing any COMMAND
buttons suitable for that component. For ex-
ample, if testing a CD player, press the PLAY
button.
If the commands work for the desired
component, you have found a code that may
work. If successful, press the DEVICE/INPUT
button to save the code.
If the commands do not work, press
and release the POWER ON button again to
advance to the next available code for that
component, with the new 4-digit code being
tested shown in the display. Continue pressing
the POWER ON button and testing codes un-
til you have found a code that works, saving
it by pressing the DEVICE/INPUT button.
7. Press the SETUP button at any time to exit the
programming mode.
NOTE: You can return to the previous 4-digit code
by pressing the MUTE command button.
RR-1061 - En-Fr - a.indd Spread 19 of 32 - Pages(46, 19)5/22/08 11:28:04 AM