Owners Manual
Table Of Contents
- Contents
- Figure 1: Controls and Connections
- Figure 2: Remote Control
- Figure 3: DB25 Connector Pin Assignments
- Figure 4: Output Connections
- Figure 5: RCA Input Connections
- Figure 6: S-Video Input Connections
- Figure 7: On-Screen Menus
- About Rotel
- Getting Started
- RSP-966 Key Features
- Unpacking
- Placement
- Front Panel: Basic Controls
- Power Switch and Standby Switch
- Remote Sensor
- Front Panel Display
- Master Volume Control
- Tone Controls
- Balance Control
- SUBWOOFER/REAR/CENTER +/– Buttons
- ENTER Button
- Front Panel: Input Selection/Recording Controls
- Input Source Buttons
- 5.1 CH Input
- VIDEO 1 REC Button
- Front Panel: Surround Sound Controls
- PRO LOGIC Button
- 3 STEREO Button
- DSP Button
- STEREO Button
- DYNAMIC RANGE Button
- Front Panel: Configuration Controls
- VIDEO LABELS Button
- SPEAKER MODE Button
- RR-949 Remote Control
- Programming the RR-949
- POWER Button
- VOLUME Buttons
- MUTE Button 15
- CH Buttons
- INPUT SOURCE Buttons
- 5.1 Button
- NUMERIC Buttons
- STOP Button
- MENU button
- Rear Panel Connections: Overview
- Rear Panel: Audio Source Connections
- Phono Inputs and Phono Ground
- CD Inputs
- TUNER Inputs
- Tape Inputs and Outputs
- Rear Panel: Video Source Connections
- VIDEO 1 Inputs/Outputs
- VIDEO 2 – 5 Inputs
- Digital Inputs
- 5.1 Channel Audio Input
- Rear Panel Output Signal Connections
- TV Monitor Output
- RCA Preamp Outputs
- 5.1 CHANNEL Preamp Outputs
- Rear Panel AC Power Connections
- AC Input
- Remote External Sensor Jack
- On-Screen Display / Configuration
- Navigation Buttons
- MAIN Menu
- INPUT SELECTOR Menu
- SURROUND MODE Menu
- TEST TONE Menu
- TONE/BALANCE Menu
- SETUP Menu
- RSP-966 Specifications
- Audio
- Video
- General
SURROUND SOUND PROCESSOR RSP-966
22
○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○○
RSP-966 Specifications
Audio
Total Harmonic Distortion: <0.03%
Intermodulation Distortion (60 Hz: 7 kHz): <0.03%
Frequency Response (line level): 10 Hz - 70 kHz, ± 3 dB
Signal to Noise Ratio (IHF “A” weighted): 92 dB (Stereo)
70 dB (Dolby Digital)
Input Sensitivity/Impedance
Line Level: 200 mV/47 kohms
Phono Input: 3.5 mV/47 kohms
Tone Controls (Bass/Treble): ±8 dB at 100 Hz/10 kHz
Video
Frequency Response: 3 Hz-10 MHz, ± 3 dB
Signal to Noise Ratio: 45 dB
Input Impedance: 75 ohms
Output Impedance: 75 ohms
Output Level: 1 volt
General
Power Consumption: 40 watts
Power Requirements (AC): 115 volts, 60Hz (USA)
230 volts, 50Hz (Europe)
Weight: 6.9 Kg/15.2 lb.
Dimensions (W x H x D): 450 x 158 x 303 mm
173/4" x 61/4" x 12"
All specifications are accurate at the time of printing.
Rotel reserves the right to make improvements without notice.
Rotel and the Rotel HiFi logo are registered trademarks of The Rotel Co, Ltd., Tokyo, Japan.
DTS is a registered trademark of Digital Theater Systems.
Manufactured under license from Dolby Laboratories Licensing Corporation. “Dolby”, “Pro Logic”, and
the double-D symbol are trademarks of Dolby Laboratories Licensing Corporation. Confidential unpub-
lished works © 1992 – 1997 Dolby Laboratories, Inc. All rights reserved.