Owners Manual
Table Of Contents
- Contents
- Figure 1 – Controls and Connections
- Figure 2 – Remote Control
- Figure 3 – Output Connections
- Figure 4 – RCA Source Connections
- Figure 5 – S-Video Source Connections
- Figure 6 – Zone 2 Connections
- Figure 7 – On-Screen Menus
- About Rotel
- Getting Started
- RSP-985 Key Features
- About the THX Ultra™ System
- Unpacking the RSP-985
- Placement
- Front Panel Controls
- Standby LED
- Standby Switch
- Remote Sensor
- Master Volume Control
- Tone Controls
- Listening Input Source Buttons
- 5.1 Channel Input
- Tape Monitor
- Recording Input Source Buttons
- Surround Sound Mode LEDs
- Mode Button
- RR-939 Remote Control
- Programming the RR-939
- Power Button
- Volume Buttons
- Mute Button (remote only)
- Input Select Buttons
- 5.1 CH Button
- Surround + Button
- Movie Filter/THX (remote only)
- Numeric Buttons (remote only)
- On-Screen Button (remote only)
- DOWN/UP Buttons (remote only)
- Enter Button (remote only)
- Back Button (remote only)
- Rear Panel Input Connections
- RCA Audio and Video Inputs
- S-Video Source Inputs
- Digital Audio Inputs
- 5.1 Channel Audio Input
- RCA Tape Monitor Inputs
- External In Jack
- Rear Panel Output Connections
- RCA Audio and Video Outputs
- S-Video Outputs
- Main Processor RCA Audio Outputs
- Main Processor 25-pin Audio Outputs
- TV/Monitor Video Outputs
- Tape Monitor Audio Outputs
- Rear Panel AC Power Connections
- AC power
- AC Convenience Outlets
- Zone 2 Connection and Operation
- Zone 2 Power On/Off Operation
- Zone 2 Audio Outputs
- Remote External Sensor/Repeater Jacks
- On-Screen Display and System Configuration
- Navigation Buttons
- Start-up Screen
- System Status Screen
- Main Menu Screen
- Dolby Digital Setup Menu
- Input Setup Menu
- System Setup Menu
- Speaker Setup Menu
- Delay Setup Menu
- Balance Setup Menu
- Subwoofer Setup Menu
- Factory Default Menu
- RSP-985 Specifications
- Audio
- Video
- General
- OSD
SURROUND SOUND PROCESSOR RSP-985
8
SPEAKER SETUP
Main ..........:
Center.........:
Surrounds......:
Subwoofer......:
VOL buttons to set
DOWN/UP to move
BACK to return
DELAY SETUP
< 1 ms : 1 ft >
Left..........: ms
Center........: ms
Right.........: ms
Right surround: ms
Left surround.: ms
Subwoofer.....: ms
VOL buttons to set
DOWN/UP to move
BACK to return
SYSTEM SETUP
Recording.......:
Zone 2 in.......:
Zone 2 volume...:
Power-on mode...:
One-line display:
Zone 2 auto mute:
Factory Defaults: menu
VOL buttons to set
DOWN/UP to move
BACK to return
Reset to factory
default settings?
YES = ENTER
NO = BACK
DOLBY DIGITAL
Compression:
Pro Logic :
DIGITAL AUDIO STATUS
Input :
Signal :
Channels:
VOL buttons to set
DOWN/UP to move
BACK to return
BALANCE SETUP
Noise.........:
Left..........: dB
Center........: dB
Right.........: dB
Right surround: dB
Left surround.: dB
Subwoofer.....: dB
VOL buttons to set
DOWN/UP to move
BACK to return
INPUT SETUP
Input........:
Input Domain.:
Volume Offset: dB
Analog Level.: 2V
THX..........:
Default......:
VOL buttons to set
DOWN/UP to move
BACK to return
SUBWOOFER SETUP
SW limiter.....: dB
Increase limiter level
using VOL buttons. Press
ENTER just before the
subwoofer is clipping.
press BACK to cancel.
DOWN/UP to move
BACK to return
MAIN MENU
Digital audio..: menu
Input setup....: menu
System setup...: menu
Speaker Setup..: menu
Delay Setup....: menu
Balance Setup..: menu
Subwoofer Setup: menu
ENTER to enter menu
DOWN/UP to move
BACK to exit
SYSTEM STATUS
Listen:
Mode :
Domain:
Signal:
Main Volume : dB
Surr Offset : dB
THX :
Rec Out......:
Zone 2 In....:
Zone 2 Volume:
Press ENTER for menu
SUBWOOFER SETUP
SW limiter.....: dB
STEREO/P/L SW....:
LFE MIX LEVEL
Dolby Dig......: dB
Dolby Dig. THX.: dB
DTS............: dB
DTS THX........: dB
ENTER enter menu
DOWN/UP to move
BACK to return
Figure 7 – On-Screen Menus